Recent content by xJames1999

I did exactly what you said I’d I’m honest haha, The only thing I’m unsure on, is which cabke goes to 3 on hive and which goes to 4, as the cables were not labelled but I’ve tried switching them and nothing happens. Could this mean the Honeywell valve is broken? It’s the original one and wasn’t...

There’s a a Honeywell valve thing? As seen in the picture

Oh right thanks. Looks like we also have a pumped system as I found this under the floorboards near the cylinder tank. So back to square one, the hive is now in non gravity mode (green solid light), so when we press hot water nothing happens, when we press hearing, the boiler fires up and the...

What’s an s plan sorry?

It looks like we are back tos quart one sadly :( Tested it by scheduling the water to come on for an hour this morning and the water didn’t come on but the heating came on, this tells me the wires are in fact the wrong way around :( However if I switch them back again, when I press water the...

Hi Ian, Thanks for that! I’ll leave it for now and see. The only issue I’m facing now is (I’ll test it again tomorrow by running hot water longer) but the pipes around the hot water cylinder were all cold, like I would have assumed the pipe from the boiler to the tank at the bottom of the...

Hi Gazfen, I did try this, and basically, when I’m gravity fed mode, either water comes on and boiler comes on, or heating and water comes on and boiler comes on. If I change then again, heating come on and water doesn’t and boiler comes on, or water goes on and heating doesn’t and boiler...

I have some news (good I’m not so sure) I switched the cables on 3/4, put hive into gravity fed mode with the constant blue light, and the receiver seems to be working, if I press the tap button the boiler now fires up, and if I press the central heating/ fire button, the tap button/ hot water...

I can only see the one valve

Sure, attached is the wiring.

Trying to get my hive to work as currently I’m unable to get any hot water just central heating?

Please see pictures of our entire system. If anyone can help me Gov et my hive fixed I’d be over the moon! Is it supposed to be on default or gravity fed for starters? As I don’t see my pumps which would indicate to me that it’s gravity fed?

Here’s the hot water cylinder with a red valve on the bottom and two red valves on the top left. I’ll send the boiler system over when I’m home. It’s a BAXI 600 with a Honeywell valve is all I can say for now

Any help on this matter would be greatly appreciated. Back story: I purchased a house with a 2020 Baxi 600 heat only boiler and it had the original 1980 danfos102 receiver/ timer and no thermostat, so thought I’d fit a hive system as they seemed good. The issue: The central heating comes on...