Recent content by YQUSTA

Is it possible to use the Strobe connection to run both the strobe and sounder?

Sorry for the delay but as requested here is the picture

Thank you both for your responses and help. I have done some more tests and here are the results. I connected the siren trigger to 0V and it sounded. so all good there I think? I tested between 12V and OP1 with the sounder test set to off and the trigger disconnected and it read 2.9V I then...

Hi Galaxyguy, the unit has been working fine, I fitted an Ethernet module which is fine and did a test only to find that the siren wasn’t working. I don’t know how long it hasn’t worked the last time it went off was about 1 year ago.

I hope someone can help too. My firmware is 3.18

Good morning, I have wired up my sounder and it wont work, as in no sound. The strobe works just fine. I have tested the voltage from OP1 to OV and when I put in to test mode it is 12V When in test mode if I apply the sound the voltage drops. I have connected the sounder to the 12V for the...

Thats great info and I will do a full power down test once it is all setup and working to make sure it is all still working and keeping its memory. I did do a power down when I moved the keypad back down from the loft to its original location. Thanks again for all the help Galaxyguy

A small update, I now have a working KP, I cannot tell you how this was fixed because I did nothing to fix it but it seams leaving it over night and powering up the system has now fixed it. what I did find out that I thought I would share is that you can test the voltage across A + B at the KP...

yes I can confirm that i am connecting to the RS485 on the right hand side of the board

Hi galaxyguy, I have waited about 5 minutes whilst I was trying to get it to work. The red led was flashing I believe but would need to double check that to be sure. I have the keypad set to number 2 as its address.

Hi, I have installed a Flex CP and have tried to start it up to begin programming but came across a problem. Originally I had a wire from the RS485 to the RF module then a wire from the RF to a KP I used red for +, black for -, white for A and yellow for B on all connections. I left the...