Recent content by zanderol24

you have been a great help mate. cheers

so I don't need to isolate at the tank? sorry about this I'm clueless.

Sorry im a bit confused so I can use plastic piping with a brass valve? And push futtings all around ??Cheers

http://www.plumbnation.co.uk/site/speedfit-plastic-ball-valve/ this one look better I think? What about you chaps?

http://www.wickes.co.uk/Speedfit-Isolating-Valve/invt/160097 would one of these work?

Ok. Can I make either of the valves fit with push fit piping? Thanks

Brill. Is the full bore ball valve worthwhile? Cheers dude

Is a full bore ball valve recommended? Any other tip b4 hand ? And thank you . Is the reducing at that point a tested method? What distance shall a reduce at? A foot? less. Thank so much

i have not done anything, my plan is to drill a hole into the cw tank, but i would like to know what flow (size 22mm or 15mm) the feed is for a salamander ct75+ shower. im planning on using push fit. i am thinking of using a surrey flange from the hwc. thanks for ur reply mate

HI one question, can i take tank cold water feed piping at 22mm and reduce to 15mm near the pump? the distance is about 2.5 metres before a drop into the pump (not yet installed) or should a just have 15mm all the way? tank connector and full bore ball valve? is there a benefit to 22mm and...