Using the Heatrea Sadia C600 boiler

DaveRIP2003 · 12 Jun 2012

Hi. I was wondering if someone out there could spare the time to help me get to know my central heating system?! It's the Heatrea Sadia C600. My question is simply about adjusting the temperature. I see the adjuster on the front panel but it just spins constantly in both directions and doesn't seem to have an effect. At the current output, I can hold my hand under the tap at full heat comfortably and I can't fill a bath, it either has to be very shallow and warm or full and tepid.

I realise that this is a basic numpty question but I'm hoping it will take someone on here a minute or 2 to reply and save my frustrations!! By the way, I've downloaded the installation and sales brochures and found very little information on this.

Thanks in advance,
Dave

McCombi · 12 Jun 2012

Haven't worked on any electric boilers but I'll try to help.
. Is the water getting enough time to heat up?
. Does your hot water cylinder have a thermostat attached to it? If so is it turned up high enough?
. You say the thermostat dials on the boiler are continuously spinning, could mean the spindle is broken and its set to a low temperature already. If your radiators are getting real hot then this unlikely to be set low.

Vic Spanner · 12 Jun 2012

DaveRIP2003 said:
Hi. I was wondering if someone out there could spare the time to help me get to know my central heating system?! It's the Heatrea Sadia C600. My question is simply about adjusting the temperature. I see the adjuster on the front panel but it just spins constantly in both directions and doesn't seem to have an effect. At the current output, I can hold my hand under the tap at full heat comfortably and I can't fill a bath, it either has to be very shallow and warm or full and tepid.

I realise that this is a basic numpty question but I'm hoping it will take someone on here a minute or 2 to reply and save my frustrations!! By the way, I've downloaded the installation and sales brochures and found very little information on this.

Thanks in advance,
Dave

Reguarding the Temp dial spinning, Thats broke so a new control pcb will be required.

Reguarding the hot water issue your cylinder will be heated by immersion heaters, The chances are the bottom one has tripped or failed.

DaveRIP2003 · 12 Jun 2012

Thanks a lot for the reply! At least I know it wasn't just operator error. I'll get the defect reported. Thanks again

diynot

If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.

Select the supplier or trade you require, enter your location to begin your search.

Are you a trade or supplier? You can create your listing free at DIYnot Local

Using the Heatrea Sadia C600 boiler

DaveRIP2003

McCombi

Vic Spanner

DaveRIP2003

DIYnot Local

Similar threads