I have a ball valve with a 300mm arm. 1/2 ones are have a 200mm arm. Not sure whether this one is a 3/4 or inch ball valve.
I have attached a picture
I have attached a picture
Last edited:
Ball valve 300mm arm
- Thread starter XanderHarris
- Start date
- Joined
- 5 Nov 2024
- Messages
- 4,916
- Reaction score
- 2,353
- Country
Just done a quick search and 300mm arm available?
It's hard to tell. Its piped up of mdpe
It's definitely bigger then half inch
- Joined
- 5 Nov 2024
- Messages
- 4,916
- Reaction score
- 2,353
- Country
Anything printed on the pipe?
- Joined
- 22 Jan 2007
- Messages
- 23,676
- Reaction score
- 3,381
- Country
I'd leave that alone to be honest and change the washer.
Thanks it would be a bigger washer on this sized valve?
- Joined
- 5 Nov 2024
- Messages
- 4,916
- Reaction score
- 2,353
- Country
Probably better splitting it down and taking the washer to your merchant/diy chain.
- Joined
- 22 Jan 2007
- Messages
- 23,676
- Reaction score
- 3,381
- Country
Probably, take it out and if not too bad a condition you can turn it round the other way and refit it. Not a long term solution but would let you source a new one.
Should be a part 2 float valve, you have a part 1. It needs replacing.
Andy
Andy
Thanks the nut wants cracking abit to turn it square. It's at a bit of an angle so isn't helping matters
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
