Search results

Few joists to notch. Own the property

Is in a bedroom so upstairs. Chipboard sheet floors

How much would a plumber possibly charge labour to move a radiator from one size of the room to another. And swap another radiator like for like. With new valves. Combi boiler system. Thanks

Thanks may not then. They recommend to use full bore isos on gravity feed systemd

Yes. I no I'm going to get restriction in the tap body. Put if I can get better flow till that point. It should help?

Can you swap the flexis that come with monoblock kitchen taps for the copper tap tails? I want to try get better flow. Thanks

Can the pressure relief from these 15 litre unvented cylinders go into a waste branch that has over appliances on it?

Would a Flexi installed like this before ok. Would be for a concealed cistern. Or would that be classed as going up hill?

What could I use as a spacer?

Thanks I was looking at these are this just a Flexi but with speedfit pipe?

It's a solid nut on the other side sadly

I have this concealed cistern 500mm it's tight too tight for a soldered bent tap connector are end feed ones tighter? Or any other ideas? Thanks

I have this tap leaking slowing constantly from the tap body. Does it need a new cartridge? I'm guessing it's the oring on the cartridge that has gone?

Interesting

Is it kind of a hard one to tell without seeing it? Thanks for any advice

It should be ok or calls for skimming

Would you think scrap any loose off if any of the top layer is. Then prime with SBR bond before tiling and should be ok?

Closer in picture

I'm going to have a look it's a picture my friend sent me I'm a plumber by trade

Would it be ok to tile over this surface? After all the old are removed?