Search results

good answer :lol: :lol:

sorry was just showing the danger of plugging or trying to repair a dripping valve yourself on an unvented system this is best left to a certified engineer would you agree?

I bought this tool and it gives me a finish like this: In about 30 seconds flat - Would be a lot better if i took my time :lol:

thought the red warning label in the video may have been a give away ;)

Thanks again I have found some cable that I was going to use to replace in a lamp - white round cable which is 2.5mm but not solid copper wire- what I would call strands I have used that - Would you recommend that I use 2.5mm grey twin and earth or is this cable ok? Thanks C PS I...

Hi Veglen At least I can help you with this :) As you know, I have fitted a water pump to boost my hot water pressure. It is a watermill BP65S and has increased my pressure brilliantly - It is a 2 bar single impeller pump for my modest 2 bedroom cottage with 2 bathrooms, and kitchen taps...

Thanks chaps I have some spare 6mm twin and earth, is that ok to connect to the JB and then into the FCU, or is it going to load the switch too much? Thanks C

have you seen this?

:lol: your welcome

don't you have to have a ticket to fit an unvented system? I think you do :lol: If you know what you are doing great, if not then you have this to show your friends and neighbours :wink:

I would agree with this - I bought an old house last year and had a crack at an angle to the 1st floor window at the rear - My father in law is a structural engineer and agreed with me that the crack was as a result of the windows being put in some years ago and the mortar being lime based so...

is the tap an high pressure tap? Probably not if its been there for some time just a thought :wink:

Ahh thanks taylortwocities. Number 2 in the picture is the immersion switch which we use for hot water if that is going to be overly complicated, could I spur it into a socket nearby using an fcu The electrical connection spec can be found here on page 5 Sorry to be stupid with these...

Guys Sorry to revive an old thread. I have fitted a pump and I now need to fit a 5amp Switched Spur for the electrics Here is the set-up in the airing cupboard. Can I spur it off 1 or 2? It also mentions that it should have a "double pole disconnection with at least a 3mm gap". Does...