Search results

I am getting there I have disabled zone 5 and can now come out of E mode but now alarm goes off when I open front door with T1 fault thanks

Just a quick update I think I have managed to programme zones I have done a walk test and all bleeps ok but I now have a T5 fault I can’t come out of engineer mode either and when I open front door I get T1 and T5

I just need to know exact button sequence in order to programme god it’s a Nightmare lol

I have got installation manual with zones I just need to know how to programme them in they are as follows Zone 1 final exit whole system A,B, omit allowed Zone 2 hall whole system A,B, omit allowed Zone 3 lounge whole system A,B omit allowed Zone 4 kitchen whole system A,B, omit allowed Thanks

I think I have done zone 1it now says FE thanks

Hi thanks for reply it’s a town house and just downstairs is alarmed entry door is set of door contacts then in Hall is a sensor followed by sensor in loung and kitchen I have a manual but just can’t get how to change programme For exAmple zone 1 thanks

cAn anyone please help me I have just installed a new PCB board for my scantronic 9800plus alarm system and it’s back to factory settings nothing is programmed in its currently in E mode and when I push 01,02,03 and so on all it says is NU not used can someone please tell me how to programme my...

I have just received my new/old board today and have wired it in there is now no fault when I come out of engineering mode just the green light so that now seems promising the Problem I got is there is nothing programmed in everything apart from default settings says nu not used can you please...

Hi just a quick update I have managed to get a used 9800 plus board that is reset back to manufacturers settings and tested all good once it’s installed I might need some help programming it if that’s ok thanks

Hi I would have to have it posted to me if you have paypal I can send you postage costs through that or I can send you a cheque also I can’t take it for free so will buy it off you and pay the postage it’s the least I can do thanks

Hi yes ok how much and how would I pay you thanks

9800 board

Hi would a 9809 pcb board be compatible with my system thanks

Do you possibly know where I could get a new control panel from complete with NVM chip thanks

Hi I have done this when I powered back up there was no sounder as was in E mode I have pressed 99 to come out of e mode but it won’t and same fault is still there on control panel me thinks that engineer was maybe right

Ok I have found the pair but AT1 shares another wire in the terminal another yellow so in the top one I have cct1 this has the yellow and blue then AT1 has the red and black but also a yellow wire and the one underneath that has a blue

Do you know what pair they are as got a few red/black and blue/yellow wires what would they be marked as on board thanks

Hi yes I have a door contact in zone 1 I have just replaced this as I think they gave up and stopped working they have a red wire black wire and the blue and yellow are twisted together and connected as well to door contact so could I disconnect door sensor and connect wires or link out what...

When I left the house with keypad showing SR the alarm went off when I opened the front door so it’s now in E mode I have sourced a replacement board for 40.00 so might go for that they said it’s tested and just need to put NVM chip in the board once I replace the board will it be easy to...

I have done that it stays same but fault light comes on thanks