Search results

I had to read this 3 times thought it was a joke ffs

Nope, you use binders.

Wrong, joists should go over the shortest distance.

Are you sure the protective film has been removed ?

Don't think so. It is an outlet screwed to the wall. As above piece of gutter missing.

Take your pick...

Fitters should have made good inside and out.

Doors been hung on the wrong side as there should be a lock block in flush panel doors.

Wrong. If the lock is damaged inside only you can gain access from outside allowing you to change the cylinder only !

Have power cycled the panel and all is back to normal. Thanks all for your assistance.

Would this mean the zone isn't set up properly as the other rf zones show rf information? The sensor seems to be working properly and has been walk tested satisfactorily.

Both sides are a shambles. Name and shame them. Hope your neighbour hasn't parted with any money yet.

Update. I have installed an ir8m in the spare zone which has cleared the high resistance but it is still showing high on shk8m zone.

The sensor is a SHK8M. Not back near the panel till w/end as its in daughter's house. Thanks for the replies.

Can anbody shed some light on this problem please? I have 2 zones showing 65528 Ohms resistance, one is not used (1004) and programmed as spare the other (1015) is set as a RF zone. The panel is a Galaxy g2-20. Thanks.

Use these badboys https://www.toolstation.com/masonry-torx-frame-fixing-screw/p92684

Your advice has not been an understatement ! Thankyou

I don't think the final zone bug would be an issue as there is an exit pir on the landing aftering entering the front door, or would it ? Obviously ADT didn't think it an issue for the previous 9 years they were monitoring and maintaining it after their original install. If I were to do the...

Thanks for the information. The RF portal is CO79-2. Version 3.00. Searching net re firmware upgrade states panel settings will be lost unless backed up with some sort of software. Would this still be the case with using the converter method and is there any other way around this? The SelfMon is...

Thanks will wait to see if he appears.