Can anbody shed some light on this problem please? I have 2 zones showing 65528 Ohms resistance, one is not used (1004) and programmed as spare the other (1015) is set as a RF zone. The panel is a Galaxy g2-20. Thanks.
Hi,
Sorry, I don't know much about alarms, but a bit about electronics!
That value sounds suspiciously close to an over-range value on a 16bit ADC - so I would suspect that 65k Ohm isn't the true resistance value, but your (1015) zone is open circuit.
But, I may be wrong and will defer to higher powers!
Would this mean the zone isn't set up properly as the other rf zones show rf information? The sensor seems to be working properly and has been walk tested satisfactorily.
If you need to find a tradesperson to get your job done, please try our local search below,
or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Please select a service and enter a location to continue...
Are you a trade or supplier? You can create your listing free at DIYnot Local