Search results

Hi,sorry if I have asked a similar question before but from a combi boiler how long should it take for the water to become warm/cold?It's a vailliant ecotec pro and it's only in the next room to the bathroom(small 2Apt)but it takes over a minute for the water to heat!Is this normal? Also the...

Thank you for your advice folks.@chris5 the top rail is exactly the same as the middle rail so I just assumed they are both dado rails? Either way I'm still not sure what to do? I think I'm going to have the top white(same as ceiling)middle a light grey and the bottom a darker grey. Do you...

I still had a gas fire/back boiler with storage tank.I don't know the difference Dan,no. I don't have a clue about these things to be honest.

The bath tap was fine until I got this combi fitted.How would you measure the flow rate Dan? There was never any pressure difference between the sink and the bath before. I'll get them out to check it out.

A wee update.With regards to the water pressure on the hot tap,I've noticed that the sink isn't affected?The pressure is fine on the hot tap in the bathroom sink but the bath is a whole different matter. Does this give any further indication as to what could be causing it?

How much would it cost to buy these parts and have them fitted?Would it have needed a power flush if it was a whole new sytem that was fitted?Ie,all new radiators and pipework etc?

Thank you my friend.I'll do this in the morning when running my bath so as not to waste any water or gas.I'll report back.P.s with regards to the picture does the install look ok?

Yes it is indeed.Thanks very much.

From a plumber/installers point of view does the quality of this work look ok?

If you hold your hand under it for long enough it does get warm.I would just i possible like it a bit warmer for baths. I'm looking at getting a shower installed anyway. It's just my mum has a ferolli combi and her water is really hot.I don't know if they can be set higher than mine.She's had...

:D

Here's a picture of of the pipework.

I read the 35 degrees as 35 litres.Doh:)

It was all new radiators and some new under floor pipework(for CH)so apparently it didn't need flushed?

There are 5 copper pipes.4 larger ones and a small one at the end that looks as though it's going outside?On the 4th and 5th pipes there is a silver braided pipe that connects to the two pipes,and both of them have a black valve on each?

This is juts a brand new combi fitted just less than 2 months ago!

I've thought about the 35 litres per minute and I really don't think it's putting out anywhere near that.About 15 minutes gets me to about 1/3 of my bath. I'm actually gonna run the water for a minute and see how many litre bottles it fulls.So after just 1 minute there should be 35 litres of water?

I'm sorry Dan I don't now the technical details of the fittings of the boiler I'm afraid?

It does get hot I was just used to it being hotter.I like my baths a bit hotter to be honest! The cold tap pressure is absolutely fine.About 4 times the speed of the hot tap!

Hi folks,I was just wondering if it is possible to increase the pressure/flow from the hot tap when using a combi boiler(Vailliant ecotec 28 pro) It's really bad. Also even with the hot water temp set to max(65)it really isn't hot enough for me. Can this be adjusted or is it pre set for "eco...