Search results

New pipes are in plastic Flexes are 30cm I think I used Speedfit isolators which I do not believe are full bore (at least not marketed as such) Boiler is a Baxi 105e I think

PS this is a combi boiler

Hi I have recently built a kitchen and have extended the central heating into it and it works fine. The problem i have at the moment is the hot water to the taps. I extended the existing run from the existing kitchen (at the back of the house) to the extension and the hot water does not seem...

Many thanks, i will try that

Hi All In my kitchen i have an island and need to cut the lip off of a board but i cant work out how to do this so that it looks straight I have tried it with a jigsaw using a laminate blade but it wasnt entirely straight. I have a circular saw and a rail saw, i am guessing that the rail saw...

I have managed to get the extender working in the dining room on both bands but still cannot get the plug/socket one working. What I will try later will be to rename the SSID on the dining room one so that it matches the original one (minus the _EXT) - not too sure if this is possible on the...

Its the slim black one, the Sky Q ER115 i believe

Hi I have Sky broadband and a very moody wifi signal. Hub is in the front room of the house and in the back its not too great. What i have done is bought an extender which goes in the back which seems to have solved this issue. BUT the wifi is now prefixed as _EXT so i have to choose which...

I believe that these are MiniGrid and yes they appear to overlap and screw together BUT the screw goes in from the back (I thought it went from the front)

Hi I have a grid switch and I need to secure the modules to the yoke. There are three small holes which are used to (I assume) insert a tiny screw to secure them but for the life of me I don't know what screw to use, I have a number of small ones in the pack but none secure them. Any idea how...

Hi I will be putting down some laminate flooring in my new extension which is around 5m by 5m plus this will encompass an already existing dining room. The question here is where to start? The footprint has many bits that i will need to cut around and although there is an opportunity to start...

OK I have got a new jig from the supplier, what I am finding though is the holes that I am drilling (test ones) are not going in straight and there is no wiggle room. The drill bit I am using is I think a 4.5mm and the screws are 4mm so I think I need a 4.8mm or a 5mm bit (the holes on the jig...

Yeah sounds like it easier to do the stand alone speaker route

Hi Im fitting out my kitchen and I am likely to end up with a couple of downlighter holes that i might not need and was thinking about adding some sort of bluetooth speaker to. Firstly, is there such and thing and secondly, they would be on the lighting circuit, is this possible? Thanks Lee

A quick supplementary question on this one. I have placed the rubber strip down the side as per the instructions but it says that there needs to be a gap of 42mm (cant remember the exact) from the edge of the cabinet to the actual unit itself. My issue is that, yes i can install it that way...

Yeah thats it

Nothing usual about this blooming kitchen I tell ya

OK

OK I tried the tool again using one drill movement from the front. Holes are good issue is the top one (or the bottom one) are not square and out around 4mm This jig is total crap, emailed the vendor and they are going to send a replacement but I don't hold up much hope for this one being any...

OK