Search results

I was looking at the Hafele jig but not too sure it can cope with 210mm centres

Was thinking of a No 6 nail to get the centre of the hole?

Yeah I think I need to get it out :( get the base level which must be slightly out somehow. I do have a spare shelf which I can put in the bottom and level out that way.

my biggest problem here is I need to drill hole on the front face which is (I think which is 2mm) and then drill the hole for the handle on the reverse to stop knackering the finish. The holes on the actual handles are 4mm (fish). I have worked out that the distance between the two holes in...

Hi I have loads of cabinet handles to put onto cabinets and I have purchased a jig which doesn't appear to be square, I have tried adjusting it (its cheap but had good reviews etc) to no avail. When I set it up and draw a line, I can see from using a square that it is not at 90 degree which is...

Hi My kitchen has a built in freezer and soon to be fridge which I am installing currently Its a Zanussi and has a slider on the door front. When I push the door onto the front of the freezer it touches the clip at the bottom but at the top it is about 5mm out. I can push the door into the...

Revisiting this one, all of this is mostly built now and kitchen has been installed. I was looking at the LED strips that i have, these have a transformer on the end which takes 240v and converts to 12v. Interestingly, the cable on the end of the transformer (the 240v end) has only two wires...

The instructions do not state this, I have a similar picture to what was posted above, but this seems to show the two cables crimped together into a double crimp end which I have never seen before

Aaah that makes more sense now, are those two cables crimped together? I have a single one, is there such a thing as a double one or should they just both be put into the connection

Hi My Bosch Induction hob has come with a 5 core cable, this cable will be connected to the hob as per the instructions but the other end of this will go into an isolator box which means I will have 2 cores spare (grey and black) - where to these connect to at the isolator side?

I'll sort one, looks like the tap will be on the inside of the panel so in theory I just need to be able to bring the feeds through the back to the taps and then the waste

Yeah unit already in, worktop in and sink in. Just need to fit the tap and the waste but the back panel is in the way

The feeds are behind the panel so I need to access them

Hi I am about to install the plumbing for my sink but the unit has a back panel, are these generally removed at installation or is there some fancy cutting needed? I think its 800 wide so I am guessing I could take out a middle section. Just not sure if I should just remove the whole thing Lee

Many thanks

1.5mm

Hi All Been looking at my wiring and have 2 switches in a room, one by each door which I want to be able to turn the lights on and off from at each switch depending on where the room is accessed. I want to understand how to wire these as I have a number of cables. At one switch I have A supply...

Ordered some from Amazon, i bet they turn up now :)

This is the part/s i am after Anyone know where i can get these quick or where they are in the pack?

Its a SMV40C30GB