Search results

Out of touch as I have no pond now but my experience is bigger the better, my old pond had this type of filter sized for the pond. It was fine for the first few years but as the fish got fruity the stock increased and it was blocking every week!

Counter sink.

I'd walk away, lord knows what else they have done!

Just use the edge of a square file.

I would say the coil is the bathroom light, the Manrose I have has an over run mine is set to run for 20min after it is switched off. It is adjustable. In your diagram there is a switched live through the switch and a permanent live to the fan directly through what I assume is the time delay...

Don't get a Blink, it only works when it feels like it and takes ages to send to the internal box, which then sends the message to your phone via a phone mast located somewhere on the surface of Pluto before sending it to you phone.

I think you are right that is a bottom fix fitting the metal looks like the head of a coach bolt with a wing nut underneath. can you break the ring, I assume it is plastic? If you were on Santa's good list the old bolt might drop through! At least you might be able to get a small hack saw on it.

Try pre-drilling at an angle and then countersink the holes.

As you suggest the makers are the best way to go there tend to be two kinds of fibre washers the red hard type an the grey softer ones you tend to see the red on water and the grey on gas but not always showers often have grey washers too. Important to get the correct one for any gas connection.

Only urgent if it is leaking or you plan on having an empty house for a long time, to turn the gas off. Fact is the chances are with a bit of leverage it will turn off if you desperately needed to. If it has a handle a lever on that will shift it or if not a decent size adjustable will move it...

Never understand football, 11 overpaid blokes on the pitch can't win a game so blame the guy sitting on the sidelines! :unsure: Might as well blame traffic cops if you get drunk and crash your car!

Well the end part is called the Aerator but I doubt you will find a bent one the same pattern. This place does a range I noticed they also do Universal spouts if you scroll down, maybe worth a try. https://www.notjusttaps.co.uk/tap-spouts-aerators.html

That's mostly scale leave it overnight in a cup of white vinegar or even better soak with some kitchen descaler . This is good. https://www.tesco.com/groceries/en-GB/products/252675391

Sounds more like the jumper (washer) on a stop cock somewhere (water hammer) or a valve in the boiler "fluttering " on its seat. Slow gas ignition is more of a thump. First thing I would try is adjusting the main stop cock up or down a bit. and see if the noise is louder anywhere else on the...

To re-pressurise I assume you mean. The braided hose is the filling loop, turn on both the valves (screwdriver slots in line with the pipe on, across off) and turn off when between 1 and 1.5 bar on the gauge. The valve on the right looks a bit mangled though so make sure you use a well fitting...

OK I am an old fella that still thinks in tenths of an inch! Only allowable if not being smelt or reported. Example, you go to do a job test before hand and see a very small drop on the gauge, after work you cannot locate it and the drop is the same. If you know where it is you fix it!

I have seen it I doubt it is damp, just a difference in porosity between block and mortar, I would give it a couple of coats of stain blocker then repaint. My go to blocker is Zinsser bulls eye 123. (y)

Odd sounds like someone as removed the pin, I assume it is not stuck in the head?

Wait, deeper plaster takes longer to dry. (y)

OK as I said I am a bit out of touch these days but it still seems excessive, I would google the makers of the cylinder and give them a call for their opinion.