Search results

thanks guys. got a double check valve ready to connect to one of the existing pipes. the water is mains fed not tank fed. the second iso valve you specify above - whats that one for if i already have a double check valve?

Hi all Wanting to get a cold supply of water to rear of garden that’s about 20m away. I have a down stairs shower room where I’m hoping I can tap into the cold water supply and feed outside with a iso valve maybe on the inside in case I need to cut off the water but was looking at the thermal...

Yes thanks that’s worked fine.

Thought so- just wanted to make sure. Will let u know if it works

Hi I have 2 sets of lights that are controlled by 2 different switches (2 gang 2 way) from each side of the room. One set of switches, they are all in the “off” position. The other side, 1 switch is off, the other switch is in the “on” position but the light is still off. So in effect one side...

Thanks got it working now. 34 en50131 is disabled 53 pd6662 is off Thanks everyone for your help again.

I had lost a lot of settings about a month ago so had to reconfigure a lot of it. So arming displays when in progress but when armed we used to see the message like “full arm” or “evening arm” but handy when you know it need to be disarmed? Will see if I can find the area settings, thanks.

Hi Got an issue where when I arm my system, full arm or part/evening arm, it works but doesn’t display this on the lcd. It just shows the date and time. Not sure how I’ve lost this but only noticed recently, does anyone know how I can get this back on pls? Thanks

Hi reading a lot of posts about this and how the outlet pipe needs to be around 16” or so inches from the ground outside. My question is that I have to cut the outlet hole but want to avoid that unsightly pipe on the outside and want to have most of vertical pipe within the sink unit and when...

Thanks- didn’t wana use too much adhesive to stick Mat to floor I will see what’s available my trowel is 12mm for sticking on tiles.

hi, what size trowel notch did you use for sticking the matt down to the floor?

Thanks mr chibs. I will get the same primer from local store. I will try the proflex to stick the mat to the floor and see how it goes.

Hi I am looking to start tiling on a new project. Have installed underfloor heating pipe work and had liquid screed poured on about 3 months ago. Heating working fine. I have had the floor polished as well. I have brought proflex so s1 bags to lay the tiles and have brought durables rolls. So...

ok made some progress here. looks like the panel lost the fact that comip was setup on com1, added that along with the ip addresses for comip as per the comip manual. made the test call successfully. so connection via app and wintex works. issue now is i cant set the alarm cos of No ATS...

Hi The internal ip address is correct and as expected within the control panel . I can ping successfully the ip from computer and when I enter in the ip address into web browser I get the comip layout diagram. Don’t think I’m using away from home but got port forwarding already setup as part...

version 8.2 im using, trying to connect over network as i have the comip hard wired option also trying to connect via the iphone app

still got the same issue with version 8 of wintex. "Connection with control panel could not be established - Please check settings and try again!"

Can’t get in via winter. Used to be able to but when using the same wintex creds it says can’t connect

I’ve tried to do a factory reset by opening the lid, turning off mains and disconnecting battery, turning on power and pressing tamper switch 3 times. Still have the same codes present. So guess it didn’t work.

Found the option in panel and the udl code is what I’m expecting and set to in and wintex