Search results

Looks like a Y-plan, hopefully you have the Hive dual channel receiver? Would say use the Drayton backplate, but you appear to be missing a captive screw. Your problem is more likely related to the motorised valve.

If it's working I'd say no you're not missing a link.

It all depends. You mentioned replacing a Danfoss FP - where was this? You may have to check voltages, could be motorised valve failure.

Where is the Hive and what is connected to heating on? Essentially, the link needs to be between heating on and the brown of your motorised valve.

This any good?

If you have removed the room thermostat and not put anything in it’s place, like a link, then you’ve left a circuit open and no way to close it unless you put a link in.

I think he means the boiler stat?

I will keep looking, can’t seem to find it but definitely saw it when I replied

Have you checked if the float valve is operating correctly? Could be as simple as that.

Does this include a suitable property?

Yes Wiser is wireless, but still needs the receiver wiring in. It appears the Tado does have the option of being a 3 channel.

If you look on the threads, I think I can see some flat parts, which means you should be able to dismantle it. However, it depends if the fitting is 1/2” or 15mm.

You do realise the question is about an immersion heater?

Hard to tell exactly, but appears to be closed already?

Maybe the mix was a little dry?

What about the dearer one?

Maybe the cost of the boiler. Is one price independent and the other national firm?

Aye, but did you read the very first reply?

Heh? If you mean bottom cable then as per @flameport - the bottom left as you look at it. Also as per @flameport you need more then 3 terminals for each as you have more than 3 cores of each wire. Grommet size is likely 20 or 25mm. Maybe measure across the diameter?

Crossover perhaps?