Search results

Do you need CO in the kitchen if there is a Ha supply in there?

Thanks everyone. SFK - it is the varilight v Pro dimmer module that I linked above. Doing some research they reckon they can handle 30 lights. I am going to pock one up and swap with the current module in my switch and see how good they are. Fittings and lamps are the same manufacturer...

If i replaced the module for the kitchen and living area switch in the existing faceplate to one of <these> would that work?

I had always thought that the max amount of lamps on a lighting circuit was determined by the total wattage of the lamps not exceeding the max load of the switch. I am on the last room of the house which i had planned to have controlled by 2nr triple dimmer switches in the following set up...

So I am ashamed to admit this but it turns out the 1/4 collet was included in the accessories bag all along . Dumb ass

I have a wagner 250m airless sprayer which has saved me so much time misting the house and doing the ceilings. I now have 15 doors to paint and am not looking forward to it with a roller and brush. Is there a sub £200 sprayer that can be used with oil based paints. I assume my current unit...

As title says. I am struggling to find a smart TRV unit that can be linked to the neohub. I want the ability (may never get used) to set individual room temps remotely using smart TRV's. I have UFH downstairs via heatmiser connected to their neohub to give me remote access to the UFH. Is...

I think i have one in the garage somewhere from previous times. I will see if I can locate it.

Thanks c-K. Given that there are minimal cuts and mainly to areas that would be covered by skirting or trims i was going to use a tile wheel for the angle grinder to make the cuts. This seems to be how i see most tilers doing larger format tiles? Is that the case?

Also what size joints would you recommend for this size tile? 5mm?

Hi i have my kitchen and utility floor to tile. It is approximately 30m2 in total. The Substructure is a timber floor on top of joists. The tiles are 600x900x15mm limestone tiles which i want to lay 1/3 bond on top of a ditra matt decoupling layer. I have tiled a few small bathrooms...

Is a standard flexible tile adhesive with 5mm notched trowel the way to adhere the matting to ply decking. Does the adhesive need to be anything special or just a normal flexible adhesive. Also is Ditra the best out there or are there cheaper products that perform equally as well.

I have a 6m wide kitchen with a 2m wide utility next to it. We are laying 900x600x15 limestone floor tiles to both. I understand 6m is acceptable and won't have issues with expansion but do I need to install an expansion joint at the door threshold or can the tiles run through the door meaning...

I ordered one of these >Dewalt DE6951< yesterday and it was sat on the matt when I got home this evening. Its a genuine part and appears to be a direct replacement for the 8mm collet that came with the router. It's £25 I should not have had to spend but it has solved my issue and I have been...

I did think of that but it came in a sealed/tagged case. Surely they don't re seal returns do they

Reading a few threads on other sites it looks like there is a GB specific model with the 1/4" collet but most that are sold are euro spec with an 8mm collet. I have had to order the 1/4" collet part Dewalt DE6951 I hope this works. I shouldnt have to do this but I really can't be bothered to...

Definately a 1/4" bit.

V

Right now I am really confused. I have purchased 3 of these units now. 2 online and 1 from screwfix. All have a far too big collet. The boxes say 1/4 - 8mm but they are far too big. Each time I have purchased I have needed one urgently. Each time I have then had to go and borrow one to get the...