Search results

Thanks can you usually re-use ball on these?

What kind of fill valve would you swap this for

So easier? The door just attaches to the dishwasher with screws into the back of it

Thanks, it's a dishwasher actually are these any different with regards to the door

Thanks and how do you cut these

Thanks so the door should swap easily enough without having to drill spaces for new hinges

Imagine depends if the recess in the door that's fitted for the hinges lines up with the place for the new hinges in washing machine

Are these straight forward to fit or awkward. I'm ok with the plumbing part. Just the door etc I'm more then capable of fitting kitchen units are doors to these but do the doors usually marry up ok on the kitchen units

That's what I originally through. But it was coming from the tail not the valve. If knocked would leak from the valve

Have used this recently and had no problems. But had my first leak on a radiator tail everywhere with it. Well it's shown up leaking after 4 months. Used PTFE for years never and issue. Used the cord for a good few years and never had a issue. Hopefully just a one off maybe I didn't put enough...

Has anyone fit any version of the below sink instantaneous type? I may have to go above sink but I have a single tap whole mixer tap.

Imagine it's an expensive tap though sottini ideal

Would probably be easier/better to change both

Thanks it's a mushroom one that's in

Thanks if removal tails, worth while replacing?

I have just regrouted by shower area with mapei ultracolour plus. And waiting the 24/48hours till I can silicone. Is it advisable to seal the grout? I have seen grout sealers advertisers but have no experience of them. Thanks for any insight.

I have a basin to swap is cracked. About 10 years old. Imagine if he best of getting a new waste for the basin. What about the tap? If I keep the tap when swapping over would you replace the Flexi tails? Would be M10 ones monoblock mixer. Thanks

Thank you

Has anyone fit one of these for a hand wash basin before?

Are these ok to fit on undersink water heater if taking the pressure relief in to the waste pipe? A tundish and trap combined? Mac-tun2 I can't seem to attach a picture sadly