Search results

Hi SFK, putting multimeter in CK and COM gives me the reading in the first photo (1.) And in CB and COM gives me the reading in the second photo (00.9).

Ok guys, got the molex connectors and yous were bang on, fit like a glove! I've got the new relay /circuit board, on one side I have GND, IN and VCC, on the other I have CB, COM and CK. To test the relay by connecting it to the existing circuit board as advised what are the connections I should...

Lol, afraid so.

Yer, definitely.

I've been looking for a replacement lower basket for my Currys Essentials dishwasher, model CID60B10 as most of the uprights have rusted away. The only one I can find is £53 + delivery which seems exorbitant. I've looked on gumtree, the internet generally and eBay for a second hand one to no...

Brilliant, thanks SFK, I'll do that and buy the two components first then report back, thanks again, truly appreciate it.(y)(y)(y)

Ha, ha, I'm all for learning so sounds like a plan.:LOL: I have measured the pitch and it looks about 2.5mm, I've realised the brick lights I was going to use are 240v. I've added a photo of the lights, I'm guessing I could remove the guts and fit a 12v compatible lamp/led? I think I'm going...

Will do, that was something else I learned this week, how to measure the pitch, at this rate I'l be a boffin by this Friday, lol

Thanks, I'll recheck it carefully, its probably me being a goon as in all honesty I'm learning from each post which I'm really grateful for.

Thanks guys, I'll take the cautious approach and get a relay. I'll check how many watts the light will need. I've looked closely at the Molex connector in the link and it looks different to one that would connect to my PCB, is there any other types I could look for?

Ok guys, I tested the middle connection and it is a switched live. When I open the garage door the connection go's live and stays live to the point the onboard led courtesy light go's off. With this in mind do I just need to connect my new 12v external lights directly to it? Do I need to use...

Brilliant, thanks, some great advice here which I appreciate massively. I'll give these things a go and report back, thanks again.

Good point, thanks, will do.

Hi SFK, I tested the contacts, using the far left and far right contacts and I'm getting 12v so I'm guessing the middle one is the switched live, would you agree and if so would the module in the ebay link do the job?

Hi SFK, understood, thanks. I've took a photo but I couldn't see any markings adjacent to it.

Thanks for this, I'll have a look and let you know.;)

They aren't very useful to be honest when I've contacted them in the past

Thanks guys. I agree it's not just a simple connection and therefore requires an add on PCB, problem is I have literally searched the globe and can't find one or even one from another manufacturer that I could use.

Hi, I have a GRD+ Gliderol motor on my roller garage door. I want to fit an external light that is connected to the motor so when it activates the light comes on. There is a 3 pin connection on the main PCB within the motor housing which states it is for an external light. However, I believe I...