Search results

It seems the wired salus setup i have van connect to thw salus hub and an online app. So probably no need to replace that with wireless stats and centre. (Anyone know if I'm wrong about this?) If (in the future) I went hive for each UFH zone. It makes sense, if I went hive wired. I could just...

Yeah that was my initial thought to get it all in the same brand, and getting the salus hub would mean UFH and CH become app/internet controllable. But above posts made me think a different route ..

No salus rad stat currently. Only have the salus wiring centre and sq610 for the UFH zones (wired) Might go hive or Tado now for the CH...

Just the built in air sensor

What would you use instead for the UFH zones (if/when these fail). I expect I can't use single channel hives for each of those 5 ufh zones?

Ok thanks. Realised now I keep confusing wiring centre with ufh control centre. Will draw again tonight and see if I make sense of it On the last question, I'm confident enough... (Will make sure I'm comfortable on paper before getting to actual wiring) ... And no money left to pay anyone to...

So in that case. The orange SL from pump can go direct to boiler in the Lr position to activate it once the chain is formed from thermostat calling?

Yep that's the one. So should I send a perm live into one of the holes too? And use one wire out to the valve/pump?

Seems Volto free. How would the two wires work from it? One wire in is perm live, then one wire out is that live out so to speak...

Haha, typo. I got it right at the bottom

Is hive programmable? I.e timer option built in

Pasting Madlabs post from other thread: You wiring is wrong, you don't send perm lives to the 2 ports otherwise they would just stay open all the time. You don't need to use the boiler output at all either, unless it's being used to power a central wiring centre. The permanent power normally...

So I have 1. Ufh wiring centre, salus 2. Ufh wired sq610 stats for each room, salus - they seem to be programmable I was intending to get for the CH (because I could make it all salus and online controllable): and remove the current timer built into the boiler - but I am open to alternatives...

Don't need to keep it if it simplifies things. Happy for stats to control everything, if a programmer isn't needed... (Guess it's only needed for CH?)

https://www.worcester-bosch.co.uk/professional/support/literature/greenstar-cdi-compact-combi-installation-instructions I have this one

Smart phone when out and about if possible. I do however have the salus controller and thermostats for UFH, so a bit stuck with those. What's so dire about them?

Ah sorry, will delete the other!

What other brand would you recommend? I haven't yet bought the CH heating thermostat/controller

Thanks I can already see where I made error with the 'brown' live, it should be connected to what comes out of my ufh controller, and the grey wire should be connected to permanent live 240 volts on the valve. Any idea on this though?

So I've managed to get 2 zone valves plumbed in, one for my CH, one for my UFH. Now on to wiring. I am using a Worcester Bosch 35cdi combi. Wiring diagram attached. I have also drawn what I think is the right wiring plan, but would like a little look over help please, anything a miss? I've...