Search results

11 volts ? That’s too low …I would wire the keypad direct onto the panel network with nothing else on the network to see if it works it could be one of the data lines down to the keypad …

lol

No because there’s a battery inside the control panel , you would have to remove that first …

This fuse

Open up the alarm box disconnect the battery and pull the fuse with a bit of luck The external bell battery is flat ….if it rings wait 20mins if not ….ladder out

You know there should be a screw in the hole near the tamper switch you screw in until it hits the wall ….plus I’ve seen the locking screw for the module missing …. Hence asking for a picture … plus if it’s got a green tamper switch ….replace it …

Who ever you feel will honour the warranty …. Example was paying £70-80 two years ago Had some in May £105 + vat Just had a quote from same wholesaler £144 + vat

That’s a really old machine …would be looking at a 4TB ….unfortunately the prices of all hard drives are sky high at the moment …make sure it’s new …check the date code on the drive

Post picture of inside the bellbox ….my guess some numpty never fitted the back tamper screw …

One of the following Seagate skyhawk WD purple Toshiba S All of the above are designed to run 24/7 I would look at the capacitors inside the machine first if they have a dome top …replace machine

Sounds like the code you are using is not assigned to A

Is there a door contact on the door ? Have you tried “yes “ A

Put in your code then open the final Exit door …does it change to A setting when you open the final exit door ….if so it’s set to intelligent set

If it is a speaker ….and not a sounder ….as below

What happens if you just put a link in the control panel end in the tamper terminals for that zone ….is there 12v connected to that cable .? As a tamper loop is a negative loop , if there’s a short to 12+ it could cause an issue

Why is it setting off the rear bell ?

Try Google ….power master user guide

Eng code **** scroll down to area….press yes scroll down to area setting press yes …what does it say ? Entry exit ? If so press no scroll to timed ….press yes ….exit engineer mode . Now try …

I think the network bus power is A and B

What’s coming out of in Volts DC Battery leads ( battery disconnected ) inc psu Aux volts inc psu Network bus