Search results

Is this return ( In blue) 'm not up on identifying on heat only. Combi would not be a problem . Thanks

Was going to just catch it with folding bucket and / wet vax. Do not really wanna drain out lower incase block although unlikely is elsewhere or don't get block out and has a nightmare for some reason back filling. Just feel more comfortable doing it this way .

First time fitting on a heat only system. Just want to be sure before start . Got no problem with bunging f n e and vent. Isolating water and wet vav ing the remainder water in pipe so no water when cut it. But I think I have got the flow and return arrows wrong way. Return is after pump going...

Sorry for confusing. It's spinning free left and right stopping each way. Maybe partially blocked at T then water taking path of least resistance up the feed. I think I'll bung the tank. Isolate water to f n e. Then clean f n e. After that open the t conpression and check if blocked. Do you...

I can remove the front box to get at gate valve. Few screws amd the full piece of ply comes of. I recently got a engineer to change 3 port valve. I think he may amd shut gate valve but unsure and maybe its stuck shut. Althoug the handle is spinning freely. Do you mean unlikely the gate valve...

To fit a Ady filter on return

I used magnetbat the t today although it was only a fridge magnet as I was waiting for a more powerfull magnet to gdt delivered. Which it has today. So will try the t again tomorrow. If the magnet does not stick to the t tomorrow. Do you think I should check the gate valve first ? I'm thinking...

Today put thermal camera on and it's obviously hot on feed. Got in loft to look at f n e. Ball valve was working. But the feed was bubbling. I suspecting block on the t or faulty gate valve. Thermostat is new and 3 port valve. Controls OK and turning pump off. What you think. Block feed and...

In my picture below have I identified correct for flow and return pipes ? Thanks in advance

Have you ever used a galo gun to unblock main cold feed ?

If I do not have room for a lever valve is a 15mm standard isolation valve what you shut off with a flat screwdriver sufficient for the ch feed off f n e ?

Yes to be safe from snapping the valve Thanks. I'll get a new ball lever valve incase. Then may bung the f n e and remove valve first and see if it was faulty. I can then look down to the t.

I suspect I have a blocked feed T on the system. When hot water is heating up there s banging on pipes. The system recently had a drain down to replace a 3 port valve. I do not think the feed was isolated by gate valve or tank bunged and may have pulled sludge in on re fill. Going to check...

It does but not the fuse spur. Its not end of world. As I can still wire it. But would see about 2 inch of cable. But wanted it more tidy.

I would have to leave the grommet off unfortunately if did manage it

Bathroom above with sink fitted directly above. And correct its a solid wall. I could get the side piece of the metal back box easy as is From going inside the back box

It's a internal duct on extractor ( filter)

I have spare tile but only 1 left. Tiler wreckons there's a chance could break other tiles around it

Image of where cable needs to go

We forgot to put the feed in for extravtor. I don't fancy removing the tile. If I get a hole drill fir cable behind where ectravtor is going to go. Is thete any tool that could drill wall amd through side of back box to get cable in without breaking the tile ?