Search results

Looking at buying a magnaclense. Seem some second hand ones on ebay. Question is will a brand new one be alot more effective than second hand. It is only for personal use to flush a microbore system once a year ?

I put central x400 in system 4 weeks today. I flushed out today but have realised I may not of flushed 3 of the down stairs rads as I should of used the drain offs on the downstairs radiator separately. I would of got most out but may of left a little in. I can't get it flushed again but...

Looking at buying a magnaclense to clean a microbore system and maintain it. I have a Fernox tf1 ( black) filter on the system. How can I connect the magnaclense without the magnifier. Can I connect it with a adapter to the radiator valves if I remove a radiator ?

Just another question. I'm thinking of cutting the bend off the crome going underfloor so can put a 90 crome on. Be able to disconnect for tiler then. I can see there are crome conpression but are the other crome 90 pushfit ?

A new chrome elbow ?

I have re ordered solvent weld . To do it in that while floors up

Tiles are big. 1200mm x 600mm

Yes I'm going to put timber supports in and clips. I can change to conpression if better

Managed to get waste in. Question now is I know nor ideal but I had to use straight conpression to convert from crome to pladtic. . Then I used a push fit elbow to get out wall.. I could change the pushfi elbow to conpression. But would you feel OK having these connection under floor. ? If...

Yes bath can be removed and a hole cutter for tile but the crome pipe is a bend in one. Would I be able to slide tile over crome and around the bend ?

How would you best tile around this waste ?

If I rotate the trap 180. It clears a joist . However this goes above a cabinet in kitchen. In original position the ceiling is out in kitchen below bath so I was going to connect below. How do you connect above and leave for tiler if I rotate trap As if trap is connected the tiler cannot...

Or can I get a 32mm to 40mm conpression elbow to move horizontal abit and just take a notch out joist for compression fitting to sit in ?

Got a another problem now. I got the 32 mm to 40mm conpression on amd drilled hole through plyboard for trap . Hit a joist and cannot move bath left or right due to space. Lucky ceiling is out below but I do not really want tp hack loads of the joist. Can anyone advise if they think OK to use...

Hi Yes I took Stanley to the 32mm nut yesterday and got it on . Thanks

Either end of compression won't get onto the 35mm crome. 32mm side or 40mm side. 32mm nut won't even get over the crome

Anyone know best way to get from 35mm crome to 40mm plastic Just tried a 32mm compression on one end and 40mm on other and either side will go on 35mm crome. I have seen a crome to 32mm connector online but not crome to 40mm. Picture below a compression fitting which will not fit .

Will 32mm compression fit onto 35mm chrome pipe ?

Would one of these work ?

I have a crome bath waste and have been trying to connect a 40mm hepvo waste trap to it but it's way to big. Tried a 32m which could not go on. I measure the crome end and it's 35mm. How do I get a trap to connect to this secure ?