Search results

Having considered the application, some reinforced plastic pipe, about 11mm o/d, nipped and pushed in, will be suitable.

Its an over the bath square shower curtain rail. An old Wilko brand product. It has inserts that reinforce the rail joints but they're all broken so I'm trying to source some fluted bar (if that's what its called) to repair the joints. The bar fits into oval tubes 9mm x 12mm. The photo shows...

Noted, thanks.

The radio sound is a bit 'tinny', its lacks base compare to the other clock radios I have so thinking of getting a better speaker for it. What is a good sound range for a small speaker (2" diameter) to give a decent base sound?

If of interest, a YT video for a similar belt change quotes these torques.

Regarding the water pump, I presume its replaced it as with VWs when fitting a new timing belt. The Gates belt kit includes the pump whereas the Ina offering is only the belt and tensioner, the pump being a separate offering.

Then VW come along with their stretch volts so its torque + 90°. Anyone read the official tightening sequence for the drive shaft nut on a Bora TDI?

For the water pump, I'd say 5Nm since that's was official for the water pump when I did my Bora TDI belt change. I inquired on the Forum website so perhaps I'll get feedback. Also need to establish if the shafts need to be locked before the belt comes off. Its a single cam so not too complex...

2019 reg 356 1.4, 843A1000 code Since its @ 48k miles and the recommended change is 54k miles, I need to prepare to do the change. Can any Tipo experts quote the torques and special tools needed please? Will likely fit a Gates belt kit. I've had Gates part no KP15503XS-2 quoted to me.

I've discovered that the clock radio has both DAB and FM. I changed to FM and the station I listen to is spot on. From what I've learnt here about DAB broadcasts, I now know why the other DAB radio I have out in the garage keeps loosing the station.

Managed to get one via ebay from a breakers yard in bonny Scotland. Had to spray paint the cover but all is well.

Went to a local motor factor and got a set of NGK.

I got it 2nd hand! Its only bother is loosing reception which I can establish by moving the wire antenna around hence I thought a broken antenna. I got a bit similar wire, soldered the resistor end of the antenna to one end then soldered the other to the PCB. Reassembled the unit but the loss...

Its a no on the cross reference it seems even though the thread and depth are the same.

I've found a set of Bosch FR78X Super 4, still sealed in the box, that I got for an i20 years ago. They have the same seat, thread and depth as NGK ones so just trying to establish if they'll fit in the Tipo.