Search results

That’s what I mean. When ticking over it’s not even close

That screw will make no difference as the lever that touches it isnt even close when its running. I bent back the lever of which the spring that was missing connectrs too. It now runs a lot better thanks.

I assume you mean this one. Job for tomorrow.

So this is the outcome this morning. Throttle lever right up in hare. Pushed left all the way to the left so choke closes as much as it can. Clamp up the cable. Fit new spring to top of carb. As I operate throttle lever & watch choke butterfly With throttle lever right up on Hare I see...

Lever all the way to the left & this is how far the choke butterfly moves. This is its full travel / position.

yes I can

I seem to move it as far left as i can but its knowing where the outer cable is supposed to be. I then do up the screw & it seems to go to position in video

I drilled another hole to move throttle lever down the handle a touch to give me more at carb end. So you say not enough do i just need to move outer casing left or right or do i need to start again

This is the best i can get it, What do you think, This is choke only. When i operate throttle lever there is no movement on the part linked to throttle butterfly on top carb. Is that because i havent installed the spring OR because engine isnt running as i see there is a linkage from it to...

So as you have seen that the choke comes on after full throttle would I be correct to say & do the following. Throttle Lever at Hare. Move lever so choke flaps comes into play. Clamp cable up. Then when using the mower have the throttle lever right back to Hare thus choke now on. Run...

Ok then clamp Clamp cable up.

Post #12 mentioned spring was missing. One in the post to me. So I read what you wrote about clamping it up but you then asked if the lever could be moved more. So yes it can. So do I then do as advised or because the lever moves more I need to do something different

Here is the second video clip. VIDEO CLIP

Did you spot the spring was missing,need to get another but its so light that wont be an issue at present. I will look to do what you said soon. Mower is in conservatory at present

So please see my short video clip so i understand what was advised above & with a question reference the lever arm position, its actually metal. SHORT VIDEO

awaiting reply in my next post

So today the cable has arrived & ive taken some photots as requested. The cable just reaches where it clamps down so thats its position. I now need some infor please on where throttle lever should be in relation to where govenor arm should be befor i clamp it down.

Yep cutting it is fine. Awaiting cable to arrive so will send photos once here. Don’t suppose you have a video showing how to position arm & talk through what to do ?

So a few weeks ago I fitted a SP474 engine & bars etc to a larger deck as my deck had seen better days. Well after a few days of using it yesterday the throttle cable snapped. Haven’t a clue as to how as the cable is the solid type as opposed to a multi stand wire cable. So I have now ordered a...

All done & works / cuts a treat As there is no label on the mower im unable to say what model etc it is. Ive fitted a 18 inch blade if that helps. I would be looking for some spare wheels. The front just spin on the axle but the rear have a tooted gear. It has a metal cogged gear which engages...