Search results

Just follow the panel settings from the selfmon site exactly and it should all work. GalaxyGuy's your man though :wink:

yup sounds right to me. You really need to read and understand the manual.

Yes but you also need to make the other connections as I mentioned above in addition to the negative to Tamper link

You need to connect the "GND" to the switched bells output. It is labelled with a symbol of a bell and has 1003 just below it...

Ok exactly which connections have you got your wires going to on the panel?

Check the setting for the output on your panel so that it is -ve switched

It's hard to see from your picture of the sounder but it looks like you want to connect #2 to 12v on your panel and then GND to your bells output

But did you set your downloader id, ARC IP etc?? You will still need to use the RKP to configure your zones etc.

You will need to setup the LCE to the correct settings. Assuming you are using SelfMon then the panel settings are available at www.selfmon.co.uk once you've logged in. You will need to configure your panel using the keypad in Engineer mode; to do it with a laptop will require the Honeywell...

If the system isn't graded then one I have done on uPVC doors is to embed a reed switch in one of the channels on the door frame and fill the channel with white silicone with the reed being a fraction of a mm under the surface of the silicone. Then mount a powerful neodymium magnet tucked...

Thanks again, that's this weekend's job sorted then :)

Thanks for the help. Sorry about the 'waz' quality of the photo, but I'm afraid that's the best I could manage in failing light after work and without a ladder. I appreciate the identification though :) Are these Marley tiles just kind of hooked onto battens? i.e. IS it easy enough to...

Hi, I was hoping someone more knowledgeable than I could help identify my roof tiles. More specifically I need to source a suitable vent tile for bathroom and shower room ventilation as the previous owner of the house saw fit to vent these into the loft (of a steel frame roof!)...

Thanks for that, I assumed it would be ok, just wanted to sound it out with someone who is more knowledgable than I :)

Yes you can... You need to make sure the new transmitter is on the same channel as the receiver (dip switches and jumpers). Read the manual.

Thanks Frank, You're quite correct it would have been really helpful for me to show what is supporting that beam! Directly under the 'stitch plates' (what are they really called?) there are both supporting vertical timber and masonry. So the unsupported span is only 2.6m Thanks

Hi, My garage door opening is somewhat too short and I am looking to raise it slightly. It is currently restricted a supporting timber that runs across the top of the door with the roof joists (flat felted roof) rest directly on top of. I am wanting to remove this timber. The joists...