Search results

Hi there Our hot and cold pipes to thermostatic shower are the wrong way round and shower can only do either hot or cold water. I tested the shower by turning shower bar upside down which worked. Basically I need to switch the pipes round and wondering what would be the most effective way of...

Great thanks. Will do.

The new branch pipe is temporarily terminated with one of those speedfit plastic ends. There's no isolation valve. Could take the plastic end off as it's installed of the bath.

I haven't actually connected the shower yet. I think your suggestion of cleaning out the kitchen tap is first step to take. Now I just need to get the aerator off, it's a bit stuck.

I've the old elbow so will give it a go. Thanks

Yes it's possible. Will try and clean it out. Thanks

Thanks The weird thing is the bathroom sink pipes seem to be functioning very well. Is there a simple solution? If not, what the more complex solution?

Hi There I recently changed a hot water compression fitting elbow to a tee in bathroom so we can fit a thermostatic shower. I noticed the hot water pressure in kitchen seems to be a bit lower after this maneuvre. We have a greenstar combi boiler btw. Any thoughts on what might be the cause...

Hi There I am about to tile 3 walls around a bath and bathroom sink with 50 cm x 25 cm tiles. The problem: The 2 side walls around bath are 8.5 cm higher (and slightly curved) than middle wall behind bath. The simple option would be to tile middle wall with full height tiles which almost...

Thanks As it is right now the soil pipe is sloping down toward the wall. If I cut it roughly in the middle the pan will be about 5 mm higher than soil pipe. Better measure it again though to be certain.

Great thanks. That makes the whole thing a lot easier

Thanks I know the soil pipe looks like cement but I am pretty sure it's plastic that's been painted. Feels like plastic when I tap it (and sound like it too). The external soil pipe and bend into the house is also plastic. My friend who sometimes helps me had a concern that if we cut the soil...

Hi there I've bought a new toilet. The waste outlet is approximately 2.3 cm lower than soil pipe. I am going to put either 5.5 mm or 9 mm plywood and 3 mm vinyl on the floor which will raise the floor but it's still slightly short. As you can see from the images of the of the old toilet it's a...

Thanks for this. That's a very good idea.

Thanks The company I buy vinyl from recommended plywood around 5-6 mm. The current threshold is actually just an extension of the exsisting bathroom floor so same height. I did think of a transition strip but a bit worried someone would fall. The stairs are in an awkward place

Hi there I am redoing bathroom at the moment and the phote shows 2 steps leading up to the bathroom. I want to put plywood on bathroom floor before thick vinyl. My wife thinks it would be a potential trip hazard raising the floor and is worried about someone falling down stairs either going out...

O.k thanks. That makes sense. May ask the electrician to remove the live and neutral from inside consumer unit.

Actually it's a switch. It's located in the boiler cupboard.

Yes true. One more question if you don't mind. I removed an old electric shower as we're installing a thermostatic shower instead. There's now an unused socket (possibly 45 amp). Should that be removed or is it safe to leave it in?

We already charge our toothbrushes in the bedroom but thought it could be more convenient to charge them in bathroom hence some kind of socket needed. Didn't know about mirrors with sockets. Sounds like that could be a good option