Search results

  1. A

    How do I connect to the male thread of a dielectric coupler?

    You wouldn't put a fibre washer inside that female iron fitting ?......i would plus ptfe on the plastic.
  2. A

    How do I connect to the male thread of a dielectric coupler?

    That won't work as the centre part of that tap connector would have to fit inside the plastic fitting and i don't think it will. A few fibre washers inside your female fitting and ptfe tape or jointing paste will probably sort it.
  3. A

    Will a Flexi pipe seal on this please?

    If you are talking about connecting to iso valves then buy a flat top valve.You could also add a fibre washer into the nut if you are worried about the rubber washer.
  4. A

    Stripped thread in bleed valve

    The thread will be BSP. Drill it out and then tap it with a 1/4 inch BSP tap.You can then screw in a 1/4 inch brass nipple and a female cap.The cap could then be used to bleed the rad.
  5. A

    Come On England

    The only player (?) ever to get booked and carried off without playing..lol
  6. A

    I would appreciate some guidance regarding existing Air Admittance/ Durgo valve

    No lower than where the waste exits a bath,basin or wc. Yours is too low
  7. A

    Gas Valve issue in old boiler

    The GC no is 47-719-03 and the part no is what you have above 6187611
  8. A

    Sink waste issue

    Sink would be 11/2"
  9. A

    Dripping kitchen tap

    You can replace the whole cartridge,if you know which one it is.There are a lot of different types. Or you can just replace the ceramic disc for a couple of ££'s. Do you know the model of tap ?
  10. A

    Basin tap fitting

    I think the tails on that tap are 3/8 BSP ?...so you might need 2 of these 15mm x 3/8 bsp male adaptors.
  11. A

    Smell from kitchen sink pipe

    Google 110mm to 40mm waste pipe adaptor.
  12. A

    Drilling hole bath tap

    The last one i drilled was about 28mm..The tap thread will be 3/4 inch BSP which equals about 27mm.
  13. A

    Is this just a cartridge than needs replacing in a tap, or is it the whole unit?

    If that has snapped off inside the tap then you might need a new tap ? If it is not snapped then you can replace both hot and cold heads for less than £15. Look at bath tap replacement heads online.
  14. A

    Covering concrete garage

    I clad mine in T&G shiplap . Put vertical batons 400mm apart and clad.
  15. A

    Tap problem

    You can get 10mm and 8mm tails which might be smaller than what you got. Take one of them tails with you to screwfix or wherever.
  16. A

    Advice on installing inline shower filter in loft pipe run

    Buy two of what you linked above and a 1/2" brass nipple like this.screw it onto the filter and your flexis will then fit ok.
  17. A

    Buzzing pump

    Not an Immersion heater ?...they can make a buzzing sound.
  18. A

    Ptfe on 1/2” thread

    Shower hoses are normally female both ends and come with their own washers.You should not need tape.
  19. A

    Replacing a sectional garage roof

    I also double bagged mine and took it to the coucil waste site free of charge.
  20. A

    Terraced house neighbour has replaced their roof and left rear roof join like this...

    If you know someone with an Ancestry account you could check out the electoral register.
Back
Top