Search results

  1. N

    Concrete Steps

    Hi, I plan to build external concrete steps (3 x steps). The ground area will be approximately 84 X 84 centimetres. How deep should the foundation be, please?. Thank you.
  2. N

    Fitting new WC

    Dilalio mentioned whether the Flexible hose will do rather than the Offset. So, I have provided a drawing to illustrate the present layout. Height of the outlet from the WC is approximately 140 from floor level. Height of Inlet to the Soil Stack is approximately 95mm from floor level. The...
  3. N

    Fitting new WC

    I am not a plumber, so I am wondering if using the Offset, and the distance between the outlet and the inlet is sufficient to allow good flushing. Or, if I would need a longer 'run'. Thank you.
  4. N

    Fitting new WC

    Hello guys, Using a 60mm Eccentric Offset Pan Connector + extension, I am fitting a new WC Pan. The height of the inlet to the soil stack is 95mm above floor level. The height of the WC outlet above floor level is 140mm. The distance between the two, offset and extension, when fully...
  5. N

    Set TV to watch Freeview (& Other Free Channels) Only

    Accelerator, you were not compelled to answer my question. You could have ignored it. It is only because (on the internet) I have read so many opinions, I was only seeking advice on this forum. To everyone else. Thank you.
  6. N

    Set TV to watch Freeview (& Other Free Channels) Only

    Hi, Medion TV I do not want to buy TV Licence. I want to set up to watch only Freeview & other Free channels. However, I have noticed this > Setup > Once complete, your TV will display available Freeview channels, including BBC, ITV, Channel 4, and Channel 5. But, BBC, ITV etc. are not...
  7. N

    Radiator valve Caps

    Great. Thank you. Will get those.
  8. N

    Radiator valve Caps

    Hi, I have found it somewhat difficult to get radiator valve caps. Please see photos. Can anyone say where I may get any of the type shown, please?. Thank you.
  9. N

    Fitting Carpet Grippers On Concrete

    Hi, I am fitting Carpet Grippers (Royale Carpet Grippers) in a number of rooms. I need to fit Grippers where there are concrete hearths, but I am unsure of the best secure way to do it. Soudal 'Grip All' is supposed to provide a strong bond on concrete, but I am uncertain. Not keen on doing...
  10. N

    Carpet a Bit Short

    Hello guys, I have rooms where skirting board to skirting board is 5.07 Metres and 4.955Metres. Buying Online I can only see two Widths, 4 and 5 Metres. Any suggestions, please?. Thank you.
  11. N

    Fitting Quadrant/Carpet Grippers/Carpet

    Thank you. Gap between skirting board and floor. Crazydaze: In that case, I may need to fit a small strip of timber along that area, say about 20 x 20mm or 25 x 20mm.
  12. N

    Fitting Quadrant/Carpet Grippers/Carpet

    Hi, Due to the gap between skirting board one one side of the room, I have fitted a 19mm Quadrant. Now, I have begun to wonder if fitting carpet grippers next to the quadrant, I can still secure the carpet in that area. I have not ordered the carpet as yet. Should you feel I have done things...
  13. N

    How to use use in-built Filling Loop/Glowworm 30C

    Ok. you mention 2 handles, but I would not know the sequence, or which one does what. I had an Ariston, but the filling loop was manual. Please see photo as attached.
  14. N

    How to use use in-built Filling Loop/Glowworm 30C

    Hello guys This Glowworm boiler has a in-built Filling Loop. The User Manual does not say how it should be used. On Page 10, is says > '.Once a month, check that the pressure in the central heating system, which is displayed on the user interface, is between 0.05 MPa and 0.27 MPa (0.5 bar and...
  15. N

    Radiator Brackets (Fitting centres)

    Many thanks for your responses. Horizontal play will do. You should have told me about the Plywood before, Ha Ha . Great advice. I will remember next time.
  16. N

    Radiator Brackets (Fitting centres)

    Seems the file is not attached.
  17. N

    Radiator Brackets (Fitting centres)

    I recently removed lathe and plaster from a wall Alongside existing studs I fitted 2 x lengths of 4 X 2, intending to fit a 400 X 1000mm radiator. Fitted plywood and plasterboard, total thickness of 21mm; re-plastered. I left the bracket fitting centres on the 4 x 2s at 800mm as shown in the...
  18. N

    Which Tool to remove paint

    I apologise for the pictures which did appear as 'Uploaded', but did not get through. Thank you, Foxhole, that tool is the one I am using alongside the scraper. With plenty of action it is working.
  19. N

    Which Tool to remove paint

    Hello guys, I have applied paint stripper to some door frames/architrave in preparation for painting. Due to the design of the architrave, it is proving difficult to scrape off the stripped paint. The tools I am using is the one shown in the photo as well as a scraper. Does anyone know of...
Back
Top