Search results

You asked to tip up mower on front then rear of which i did but veer wasnt there until i put all 4 wheels on the floor. Can you exaplane / whats happening there then

Today ive done the following but still the same so may just have to put up with it. Removed all wheels & lubed up each wheel & replaced. Removed height adjuster bar front rear left wheel to front left wheel. Theres no bush as such on rear wheels but just a triangle piece of bracket with a hub...

Correct as some people help but dont follow post.

YES both about 670mm See post #12

yes All taken apart and checked and cleaned and all spin with ease

The axle is just a shaft going left to right with a couple of springs. When mower is on the floor I don’t see it bigger one side to the other so I would say this is ok.

I advised I’ve removed the internal cogs / gears so now wheel just rotates on the shaft. It’s now a push mower. If the blade was a different height wouldn’t the grass Ive cut also be a different angle because it looks flat to the ground. It’s not giving any signs as if mower is cutting a slope.

Thats easier said than done but when rear wheels off ground im sure after a few times it doesnt happen. I then did the same for front wheels & i was expecting it to veer off but im sure it still was straight again. You would think maybe at least one of them would give you the issue at least...

Ive just swapped both front wheels around & its still the same so put them back as it was. I then did the same to rear wheels & also the same so also put them back as it was. Centre of rear axle shaft through wheel to front axle shaft through wheel is say 670mm & looks to be the same on both sides

Question for you then. If mower veers to the right is the problem, On the RIGHT or the LEFT ?

Ive sprayed up all the wheels & there moving parts & none are sized / drag etc & all move freely. If i disconnected the height adjustment bar from rear to front wheel, will this point to front / rear issue just to help pin point where the issue is ? Basically as now not a self propelled mower...

Is this another joke or am i missing something here

I have removed 1 wheel at a time & cleaned using carb cleaner, then used GT85 spray & re-fitted wheel. All spun fine before cleaned & also after being cleaned Lever is fine & i dont see any issue with height of grass when looking back at what i just cut. The lever is welded to say the axle &...

The mower is shown in photos supplied, ignore model number on engine as different engine fitted to deck. It was self propelled by gearbox died so its only used as a push mower for certain height grass which isn't that often. The gears inside the wheel have also been removed hence now being a...

Amazon & here tomorrow £15

Ah ok. So next time I hear it chugging stop & fill it up. Dirt obviously got passed that filter in tank

I hold it and unable to blow. I’ve watched it for 20 minutes and not a drop has come out. The needle rubber tip seats and that’s it.

So for the 5th time I’ve had it apart & back together again. Done nothing different & used same parts ie haven’t swapped anything. I’ve just put fuel in tank & no leaks. I’ve also just cut my lawn. Even left it running for a few minutes & mower deck is dry. Very strange. Now I need to add 3...

Looks fine. I see fuel coming from between carb / engine block also opposite end towards air filter I see no fuel in float. I operate float & unable to blow. I let got of float & i can blow fine. I see no reason for it to do this,

The float seems light meaning no fuel in it. I just conncted fuel pipe back on & held carb in my hand & fuel came out again. So answer me this, IT can only be the float at fault here correct ?