Search results

Put an end trim where your green line is up wall cut so its wider at the top maybe. Could always straighten that corner which is a bit more involved

2kg box of toupret. Do it in 2+ goes giving it an hour or so for first mix to set a bit so it don't slump out. Try not to mix more than you need or you will be throwing away good filler

Should be a good fit but when I've come across problems like that ive put a stainless steel screw through

Remove rubber and clean or replace. I've got two myself I need to fix as the rubber gets dirty or slime grows underneath it.

Oddly. And it's true. Mods aren't here as much as some of us. I mod a site and I can go days without looking so I think it's down to exposure. If you hit ignore after reporting the post, it disappears so that's the best thing to do.

I don't think you will move that. I've got several patio slabs on a plank ATM so they don't scratch the new slabs under. The plank is a bit twisted and the slabs have made no difference even with the weight

I hired a pump for the 4 days before inspection. Sun came out and dried it mostly before concrete. Not a problem but was stressful when it was hammering it down. I got the wrong type of pump as well and couldn't get it to prime in the shallow water so had to swap it.

Use a polymer like CT1 or Stixall. Fill Use waterbased paint over as a primer or topcoat. You have to use waterbased over first! Use multi solve to clean up if you make mistakes

Depends how well it preps. If the wood is good stain. See wood grain through. If it's poor and needs filling use opaque wood stain like mahogany or other. It's a paint that's looks like a stain colour covering the the wood so you can't see the grain. Or you can buy something like zinsser all...

Consider the weight. Max is about 200kg per square meter. Could be less if a wooden floor. I've seen floors buckle under weight in the past

Marketing. Real world this stuff goes in the skip.

Worst thing could happen is you isolate the tap until they get back I guess. Crack on

There is a specific saw for cutting that make it easy. Last one I fitted I just use 50mm insulation then stuck on plasterboard over as it works out cheaper. Not something I've done loads of

Not noticing asbestos companies means they either didn't know or never cared and got rid of it. It's possible it was tested and was fine. Always worth asking neighbors.. I've ripped up loads of underlay over the years from old houses. Can't say I even considered it could be asbestos

If it bothers you get it tested

Looks likely you can. Turn water on. No need to get it tight when you fit new one. Just a gentle nip up. You need to get water out cistern first with sponge and dry up. Get that inlet off. Get that far and it's all good

You want to change valve of have ago at swapping valve rubber?

Product is ok and you need to follow the data sheet application. I guess you don't have a cavity wall, just a single skin? CharlieDIY on YouTube has done several videos trying out different systems. Maybe look at those and decide which is best for you. You can also phone the technical...

Can't say by looking at pictures. If it sounds hollow or in poor condition it's going to have to come off. I've been following this DIY guy that's removed all the house render. Been on a rendering course and doing it all himself. Maybe you could watch for interest..

Be fine. No weight. Probably be fine without but if you can get one in cheaply why not