Search results

Anyone carrying out an EICR I suppose.

Considering most older installations had the cooker switch dead centre right above the hob/cooker, I really can't see anyone turning that off while a frying pan is on fire on that cooker. The only two purposes of cooker switches are isolating while working on a hard-wired appliance/replacing...

The problem is that Luisete needs to physically locate the old transformer in the house to be able to replace it.

This is just a guess but I‘d think there‘s a layer of metal or flame-retardant plastic behind the timber and there‘s definitely plastic around the contacts on the socket face. I‘d assume that’s what makes this type of socket acceptable.

That wouldn‘t comply for a new install, would it?

Not in the pictures but OP will need that since the switches won‘t fit standard ones.

Are we sure OP‘s question is about the house wiring rather than how to connect an earth wire to the old switches? In the latter case, drilling and tapping a hole for an M3 screw into the back box should do. Do the brass rings unscrew easily without tools? In that case I‘d be slightly concerned...

Yes, that's how they were usually wired, each button connected to one solenoid and the common of all solenoids wired to the bell. Last year I built a working late-20s setup (original transformer, bell, panel) on my bench as a demonstration. The panel was much less ornate than this one, just a...

The wires don’t actually look that ancient, maybe post-WWII. If the insulation doesn’t feel crumbly at the terminals I wouldn‘t worry about that part. In order to use a tone tracer you‘d need to find the wires at the panel. If you can’t find them, I‘d run new wires, pretty much anything will...

I‘d suspect the only countries requiring shaver sockets these days are those following UK regs to some degree. Unless you insist on having a socket in zone 2, then it needs to be a shaver socket in quite a few places. My gran‘s bathroom in Germany, wired in the mid-70s, had a shaver socket to...

I paid less than 90 Euros for mine and seem to remember it was the cheapest model on the European market then. It claims to withstand up to 400 V but from what I‘ve read on the internet you should definitely take that with a grain of salt.

The cheaper Testboy 26 definitely doesn’t work with single wires, which can be quite annoying.

Yes, tone tracers, at least affordable ones, need two independent conductors, neither of which can be earthed. Not sure about the expensive models.

I prefer making each conductor safe individually over shorting and earthing them in case someone might want to use a tone tracer to find that cable in the future.

A neat way of dealing with the situation from an electrical point of view would be fitting a back box with a blank cover and any type of mains-rated connector to each individual wire inside that box.

It would make a lot more sense if it was „even if the circuit only supplies one or more class II fixtures“. In that case it would be pretty clear that all the fixed wiring needs to have a CPC, in case someone wants to install class I fixtures in the future.

The load limits the current and 1.5 mm2 flex is good for 16 A anyway. Also keep in mind that a 16 A MCB provides better overload protection than a 13 A fuse and that the FCU is designed to protect the flex rather than the heater.

Surely earth hasn‘t been green for a long time either, has it? The table seems suggests it still can be.

As far as the boiler and its flex are concerned that’s exactly what I wrote. However, in theory the fuse in the FCU could also serve as protection for an undersized spur from a ring final circuit to that FCU or some other bodgery. Only in that case replacing the FCU with a twin socket could...

I don't think the flex between the FCU and the boiler gives any evidence on the size of the cable feeding the FCU. Since the flex will be protected by the fuse in the plug, the only concern is whether the cable inside the wall is sufficient to supply a double socket with the boiler and a...