Search results

just fitted replacement pcb slightly different one to before honeywell replacement for a siemens but took my time and connected it as before but i,ve got a 30 degree led flashing

red h/w led flashes when switched on then goes off no hot water c/h is fine

h/w temp sensor light flashing which one is it can it be tested

hey presto it works gac i,ll get some flush can you recommend a decent one and is there a proper way to use it :D :D :D and a big thanks

by the way the pin never moved on its own

pump spinning quite happily although sounds like its got a little air in

doesn,t make a difference but have checked it with pliers and the pin moves freely

done as suggested y beerlover seem to heading in right direction pin doesn,t move recently changed three way valve

60 degree light flashes fault pressure ok what cand be wrong /

it,s the top joint where the copper tube thats got sensors on it connects to the heat exchanger left hand side of the boiler as you look at it the pipes secured with a double spring clip

i,ve got quite a selection of incorrect seals so far they tried to sell me the pipe too what type of seal is it and where can i get one plumb centre don,t inspire confidence

i,ve got a leak from the heat exchange return pipe seal how do i stop this thanks in anticipation

my sons dismantled the drier to fit new motor bearing but forget where the wires go a photo would do fine please[/img]

where can you get one from and what are they called