Search results

You could fill it with 5- 6% acidity cleaning vinegar off Amazon and leave for 4 days. That will clear rust

I used to seal them as the factory primer is very dry. There are different ways to do it and different products. I always screwed legs to the ends so I could paint one side and immediately flip over and paint the other side. No runs that way.

Live. Neutral and earth. That's 3 wires. Please take this as my concern... I'm worried about you messaging with that if you are unaware of this fact. Get a electrician to wire up.

The valve insert will need removing and PTFE tape used

You can bridge flow and return with valve in I thought? That might help. Not my area so consult a pro

Sounds like a Trv problem. They do hiss at the point they shut off. Rads can make a noise with water is flowing is through. Maybe swap one of the rads valves for a different brand to see if that helps

Push the insulation against outside wooden walls. Treat the walls like a solid single skin brick wall. That's how I would do it. Insulation is foil backed so no moisture can get through

Any fins on it? If it's old without fins I would consider buying a single rad with fins or I prefer a type 21 rad if you really think you need the heat. As for cleaner. I wonder if its really rusty inside and blocked? Has it a link at top and bottom so water can bridge? I've had trouble with...

Read the online data sheet for the adhesive. That will tell you if it's the correct adhesive for the surface and how to prepare surface.

You can get carpets 5m wide. You then buy 6 linier meters. 6x5m carpet should fit. As for buying this online I don't know.

Not supporting anything as you say

Some screens you just silicone on the outside so any water that gets inside can run back in and away down plug

Get a mould spray and treat it. Not easy to wash that but a good mould will kill it. Maybe a couple of goes at it to do the best you can. HG make a good one. Just be mindful that mould spray needs to be used with care so follow instructions.

You need to wipe the hard drive then install OS. Sounds like you are installing within windows. You can install a dual boot so you get the offer of either Windows or Chrome at startup or inside widows so I understand. Personally id rather format drive then install software. Linux mint or chrome...

If the are not allen key holes then I guess you need to drill out the rivets. Then you will have to find similar rivets which could be interesting

As above I like 12-15mm gap.

Plastic centre will sell new uPVC coated sills which is low maintenance. Or. Zinsser BIN what you have and undercoat then paint with a good white satin. Aqua guard or scuff-x for example. You could also cap what you have as a cheap alternative. Plastic centre will sell

I used soil pipe as smooth and solid. Needs to run away ( down) so any condensation runs away. Constantina pipe creates a lot of air turbulence and restricts flow. You can buy soild extractor pipe so you could use that. Also check that your inline extractor is a centrifugal fan and see how far...

Get some tested. I can't say either way. It's the only way you will ever find out.

With centrifugal fans which you will need you will get pressure loss with poor or no extraction imo. I've seen that tried before and it failed