Search results

If you can make holes line up...yeah. Cut some if you have to

If you still have a chimney opening then you need a vent to allow air flow, or you will get condensation which will cause staining. Is that's what's happening here because opening wasn't blocked off?

It a mystery why you can't buy pad savers for many sanders. I use them all the time on my festool ets150 sander. I've also stuck velcro on with Stixall or other polymer glue on my cheap sanders. If you buy a new pad try a mirka pad saver. You could cut to fit.

Holes above stairs are for drainage with all the soil behind. To the left below wall pir light is a cavity that continues all the way down. That's my guess

Has the house had an extension? Looks like a cavity from an outside side wall that's now an internal wall?

Phone the manufacturers helpline. It's a minefield all this wood treatment

The fire manufacturer helpline. They should be able to advise on part availability and stocks

Yeah. Lagging well and support and all will be fine IMO. Not my area of expert knowledge though. I found pipes rubbing against concrete or each other or freezing is the biggest problems.

Watch YouTube for how to remove and correct insert method. Also you can buy new SIM trays online cheap enough. I understand how it can be found difficult as I've had a few seconds of trouble and had to start again. It's not obvious which way around it all goes together without looking online...

My local store took on Mira spares when factory in Cheltenham closed parts shop. Check out website or contact them to see what they offer Mira 415 (1993-2001) shower spares and parts | National Shower Spares https://share.google/NkANSWjQ5Etb173pd

Mira 415a or 415b maybe. Looks same as mine. Still get parts I think... One is low pressure so works off water tank. The other is mains pressure worked from combi boiler

I don't think BG will fit part they don't supply.

Swap tap with one that has a shower hose is going to be your best bet. You will be available to control temperature and flow ect. I think you are going to struggle or be disappointed even if you were to attach a hose to that tap

British gas supplier don't stock part probably. Phone up and speak to gas fire helpline for stockiest and confirm spares are available. Then look for local person to sort and unfortunately you may need to pay. That's what I would do.

Remove that damaged plasterboard and replace. Put a 3mm stop end bead up the front corner, and another against the shelf side panel and skim up the front edge with toupret powder filler. Having 2 stop beads will make it easy to level as they will act as a guide. You just need a scraper blade...

Air vent is blocked off creating a cold spot in bathroom?

Looks like loads of meat on them

You can use 6mm plasterboard and stick it on wall with a polymer. Fill joints with toupret powder filler and sand. Paint. Not much skill required. Other option is just use toupret powder filler. 2 or 3 goes filing in allowing each go to set. Sand and paint

Lath and plaster? Lime plaster? Solid or movement when you push a bit?

Ok. Interesting... Follow that advice then.