Search results

Certainly looks like the DPC. Squirt a bit of silicon into the hole and fit one of these if you are bothered about water splashing out of the drain...

https://www.bes.co.uk/1in-x-3-4in-hexagon-reducing-nipple-bsp-taper-brass-10597/ perhaps

Have you cleaned it recently. Perhaps water has got where it shouldn't be and may dry out given time. Is the knob that controls that particular element working correctly ie turning the spindle rather than just spinning on it

As country fan says then . Possiblly the tails leaking

As I say I am not an expert in this field but I have asked the mods to move your post to the roof and gutter section where you may get a more definitive answer.

Should there be a seal between the tap and the basin

Not that familiar with Beko products but sounds like possibly the pressure switch is not detecting a change in the water level or the motor brushes are worn out or even both Check any filter that is connected to the pump for obstruction, also there may be a thin tube connected to the pump that...

You can't just install a woodburner yourself. Get some who is HETAS registered to advise you about the whole project.

Google universal router table.

Scroll down to similar threads

That sounds like a load of tosh to me. Your contract is with them not the manufacturer and if you are confident the item is faulty they should replace or refund your money in the store there annd then when you return it. There are no terms and conditions to the contrary on their website and...

I know you say you will no longer follow this thread but just in case. The owner guide herE says you need to hold the ignition in place for 20 secs not just a few. Just wondered if that would help. Owner Guide 2.0 Introduction & Operation 2.1 Introduction 1. Your Brazilia F is a room sealed...

"good money after bad"

The deposit alone is twice what I woulld have thought the job should cost.

How does it compare with the other side of the valley. Not an expert but with such a steep. pitch I would not have thought it would be a problem.

Buy a pair

Pictures?

Fasten a nut splitter to it then lever it out.

Ditto

I can'see any reason not to keep the exsisting one, but I would fit trunking running around the inside of the cabinet rather than just clipping it.