Search results

Take the lever off and turn it round.

Or, for an extra tenner you could do it properly. Your house though so crack on.

Probably a washing machine upstand https://www.screwfix.com/p/mcalpine-standpipe-appliance-trap-white-40mm/94360

You know that are using the wrong fitting so whatever you do will be a bodge. I'm sure you can find something to block the hole but why not do the job properly.

Agree. Junk it and get McAlpine.

You and I know what a sink waste is but the OP could be referring to any part of the setup. The part in the pic obviously doesn't connect direct to the waste so we need to see what its connecting to.

The narrow end of the tapered seal normally goes into the fitting. You've probably got it the wrong way round. What are you trying to screw it up to?

If the toilet is couple coupled, you will need to replace the whole lot unless you can get the same model. If the toilet is low level or back to wall with a concealed cistern, you can easily replace just the pan. Might need a new flush pipe and you should definitely use a new pan connector and...

Some bar mixers will have a greater resistance than others but there would probably only be a significant difference if you had a low pressure system. As you have a combi, you have mains pressure hot and cold and they are all likely to perform about the same. You can always try a larger shower...

Do not touch the little red lever. It is the pressure relief valve. If you pull that you will let water out of the system and decrease pressure. This is the opposite of what you are trying to do and could result in the valve not seating properly afterwards and needing to be replaced. As for the...

I was wondering how you had got on. Nice one. (y)

Multi tool or Dremel. If not available, sometimes you just have to take the blade out of the hacksaw and use it on its own. You can wrap a bit of tape to protect the hands if you like. As mentioned before, invest in some fresh blades. Also put some tape around the hole to protect the porcelain...

Looks as if the female thread in the housing has broken off. Not repairable so replace it.

You can test with a magnet. Magnets don't stick to copper but they are attracted to the magnetite sludge that builds up inside the pipes. If you have areas where the magnet sticks to the pipe, its an indication of problems.

Certainly not correct. Each cistern should have its own overflow to the outside. You can combine them together to sort your immediate problem. F&E should not be hot although its common for it to be discoloured. Sounds like the system is pumping over. This is usually caused by a blockage or...

https://www.showerspares.com/search/aqualisa-quartz-twin-control-pad-button-910751/ £99.25 at National Shower Spares. The old part has been replaced by this so should be a straight swap. I have known the controller to be at fault. If it sorts it, all well and good. If it doesn't, you can go...

Inlet strainers should be just behind the screw on connectors (can't remember for certain but that makes sense). Obvs turn water off at isolators beforehand.

https://ourbathroom.com/ This company service and repair Aqualisa digital showers. Your problem may be with the controller or the processor. They may be able to advise which. I have used the loan scheme several times for customers. You get a fully refurbished unit and send back the old one. You...

Should find what you need here. https://www.uk-water-filters.co.uk/collections/accessories-water-pipe-connectors

In that case, stick a new shower in.