Search results

Thank you will get him to take a look and would this still Pass with the bco

Evening all been ask by a friend to do single story timber frame extension Popped over to check what he needs and noticed he needs one more course on internal skin for stepped dpc Now the problem is he has cut dpm flush with concrete so can't wrap over to dpc height not being my area of...

Also search hall hooks for easy and tidy repairs

It's a north south thing called joiners more commonly up north carpenter Dan south But either should be able to do all you require some specialise in certain areas like roofing or second fixing but as a carpenter /joiner you should be able to do the lot plus a bench joiner works in a joinery...

They do one with s 110mm flage which is for 6"post I set the bracket just below ground level so hidden then have post just above ground to stop any damp so nothing really to hide

I use these https://www.tradecounteronline.co.uk/fencemate-bzp-adjustable-bolt-down-post-supports/ As also gives you adjustment if leveling a few posts and keeps them off the ground

Don't forget you're gonna need some lumber couple of 2x4s should do

And a trad house with part timber part steel frame why I don't know should of had concrete floor blockwork then roof

Plus one here doing timber frame on mine at mo

I've found the Felo bit s very good but as above with the wera bits watch out for copies

I've started a go fund me page just for you now scrap it

Don't try cutting the the alu trim it's a storm bar fitted to underside of frame so bad advise

When we run joists into oak beams we do similar but normally min 50mm bearing but looking at that may be a tusked tenon joint

the rubber on the end of the pencil just go gently

You're be good for 150mm fascia even 200

It shouldn't need sealing like that should of been sealed in the rebate but cleaning will stop it going mouldy

Will be fine if you don't want a soffit overhang if you do want a soffit remove outer block an add a couple of brickettes

The 3x1 timber you refer too are too help reduce sag for the ceiling joists are you're joists 3x2

You're only choice now is flush to block work plus allowing for any render but height depends on tiles also you may get away with 150mm fascia with vent Also if that roofs vaulted that glulams past its sell buy date also i ask the chipie that done roof but don't think a chipie was involved in that

Never had a problem with these also removable