Search results

Have you ever used a galo gun to unblock main cold feed ?

If I do not have room for a lever valve is a 15mm standard isolation valve what you shut off with a flat screwdriver sufficient for the ch feed off f n e ?

Yes to be safe from snapping the valve Thanks. I'll get a new ball lever valve incase. Then may bung the f n e and remove valve first and see if it was faulty. I can then look down to the t.

I suspect I have a blocked feed T on the system. When hot water is heating up there s banging on pipes. The system recently had a drain down to replace a 3 port valve. I do not think the feed was isolated by gate valve or tank bunged and may have pulled sludge in on re fill. Going to check...

It does but not the fuse spur. Its not end of world. As I can still wire it. But would see about 2 inch of cable. But wanted it more tidy.

I would have to leave the grommet off unfortunately if did manage it

Bathroom above with sink fitted directly above. And correct its a solid wall. I could get the side piece of the metal back box easy as is From going inside the back box

It's a internal duct on extractor ( filter)

I have spare tile but only 1 left. Tiler wreckons there's a chance could break other tiles around it

Image of where cable needs to go

We forgot to put the feed in for extravtor. I don't fancy removing the tile. If I get a hole drill fir cable behind where ectravtor is going to go. Is thete any tool that could drill wall amd through side of back box to get cable in without breaking the tile ?

Looking at buying a magnaclense. Seem some second hand ones on ebay. Question is will a brand new one be alot more effective than second hand. It is only for personal use to flush a microbore system once a year ?

I put central x400 in system 4 weeks today. I flushed out today but have realised I may not of flushed 3 of the down stairs rads as I should of used the drain offs on the downstairs radiator separately. I would of got most out but may of left a little in. I can't get it flushed again but...

Looking at buying a magnaclense to clean a microbore system and maintain it. I have a Fernox tf1 ( black) filter on the system. How can I connect the magnaclense without the magnifier. Can I connect it with a adapter to the radiator valves if I remove a radiator ?

Just another question. I'm thinking of cutting the bend off the crome going underfloor so can put a 90 crome on. Be able to disconnect for tiler then. I can see there are crome conpression but are the other crome 90 pushfit ?

A new chrome elbow ?

I have re ordered solvent weld . To do it in that while floors up

Tiles are big. 1200mm x 600mm

Yes I'm going to put timber supports in and clips. I can change to conpression if better

Managed to get waste in. Question now is I know nor ideal but I had to use straight conpression to convert from crome to pladtic. . Then I used a push fit elbow to get out wall.. I could change the pushfi elbow to conpression. But would you feel OK having these connection under floor. ? If...