Search results

Hi I have Sky broadband and a very moody wifi signal. Hub is in the front room of the house and in the back its not too great. What i have done is bought an extender which goes in the back which seems to have solved this issue. BUT the wifi is now prefixed as _EXT so i have to choose which...

I believe that these are MiniGrid and yes they appear to overlap and screw together BUT the screw goes in from the back (I thought it went from the front)

Hi I have a grid switch and I need to secure the modules to the yoke. There are three small holes which are used to (I assume) insert a tiny screw to secure them but for the life of me I don't know what screw to use, I have a number of small ones in the pack but none secure them. Any idea how...

Hi I will be putting down some laminate flooring in my new extension which is around 5m by 5m plus this will encompass an already existing dining room. The question here is where to start? The footprint has many bits that i will need to cut around and although there is an opportunity to start...

OK I have got a new jig from the supplier, what I am finding though is the holes that I am drilling (test ones) are not going in straight and there is no wiggle room. The drill bit I am using is I think a 4.5mm and the screws are 4mm so I think I need a 4.8mm or a 5mm bit (the holes on the jig...

Yeah sounds like it easier to do the stand alone speaker route

Hi Im fitting out my kitchen and I am likely to end up with a couple of downlighter holes that i might not need and was thinking about adding some sort of bluetooth speaker to. Firstly, is there such and thing and secondly, they would be on the lighting circuit, is this possible? Thanks Lee

A quick supplementary question on this one. I have placed the rubber strip down the side as per the instructions but it says that there needs to be a gap of 42mm (cant remember the exact) from the edge of the cabinet to the actual unit itself. My issue is that, yes i can install it that way...

Yeah thats it

Nothing usual about this blooming kitchen I tell ya

OK

OK I tried the tool again using one drill movement from the front. Holes are good issue is the top one (or the bottom one) are not square and out around 4mm This jig is total crap, emailed the vendor and they are going to send a replacement but I don't hold up much hope for this one being any...

OK

I was looking at the Hafele jig but not too sure it can cope with 210mm centres

Was thinking of a No 6 nail to get the centre of the hole?

Yeah I think I need to get it out :( get the base level which must be slightly out somehow. I do have a spare shelf which I can put in the bottom and level out that way.

my biggest problem here is I need to drill hole on the front face which is (I think which is 2mm) and then drill the hole for the handle on the reverse to stop knackering the finish. The holes on the actual handles are 4mm (fish). I have worked out that the distance between the two holes in...

Hi I have loads of cabinet handles to put onto cabinets and I have purchased a jig which doesn't appear to be square, I have tried adjusting it (its cheap but had good reviews etc) to no avail. When I set it up and draw a line, I can see from using a square that it is not at 90 degree which is...

Hi My kitchen has a built in freezer and soon to be fridge which I am installing currently Its a Zanussi and has a slider on the door front. When I push the door onto the front of the freezer it touches the clip at the bottom but at the top it is about 5mm out. I can push the door into the...

Revisiting this one, all of this is mostly built now and kitchen has been installed. I was looking at the LED strips that i have, these have a transformer on the end which takes 240v and converts to 12v. Interestingly, the cable on the end of the transformer (the 240v end) has only two wires...