Search results

Potentially, the government stand to lose around £28b per year in fuel duty when petrol and diesel cars disappear from the UK’s roads. No real comment from them as to how they are going to recover this money, can’t really increase the electricity tariffs across the board as non car owners would...

All these figures that the vehicle manufacturers are quoting will be under laboratory conditions, not when your crawling in traffic with your lights, wipers, heated screen, heater, radio etc on. As previously said, the infrastructure needed to go 100% electric, not just the physical charging...

Most garages will be fine, damp and rodents are your main worries. If garage is joined to your house then the adjoining wall would be preferable to an outside one.

Hikvision, good value for your money.

Mine is in the loft, mounted approx 1 mtr off the floor in a metal box with twin fans ducted to outside, been up there for over 3 years without problem. When I installed it I ran a HDMI cable along with 2 USB cables (one from the front and one from the rear of the DVR) to the room below that I...

Check the obvious first, make sure lids on keypads, PIR’s and panel are all seated correctly. You say that you have used 4 core cable for keypads and detectors, have you wired the detectors as EOL or Global tamper (you would need 6 core for Global) assuming the detectors are PIR’s and not just...

They use a “M” ring rather than an “O” ring, once they have been depressurised / demounted then struggle to seal again. You can buy a Demounting tool, bit like a circlip spanner, but better cutting it out and using either Hep2o or compression fittings is the way to go.

Osma Gold used a “M” ring instead of an “O” ring once depressurised and demounted they were prone to leaking. Best advice is to cut them out and replace.

Copper olives and a wrap or 3 of PTFE tape if required, you should keep jointing paste or any oil based products well away from plastic pipes / fittings.

Google hepcalc it’s a Hep2o UFH calculator that will produce a detailed quote and list of materials for you. It will then give you an idea of how many circuits (zones) you need and how many ports on the manifold.

I’d be very surprised if the “O” rings have failed or are failing, they are made from EPDM rubber and have to undergo rigorous testing not only for temperature and pressure cycling but also for chemical resistance (central heating inhibitors etc) and of course be WRAS approved.

I installed a CCTV system approx 10 years ago (650 TVL cameras, fairly basic DVR), upgraded 18 months ago to Hikvision 5mp System, easily set up for remote viewing on iPad and iPhone and wouldn’t be without it. Managed to capture a number of incidents (anti social behaviour / criminal damage)...

As Dan says, a photo may help. It will probably be either Speedfit or Hep2o, newer Taylor Wimpey houses should have Hep2o installed, some of the older ones had a dual specification and could be either Hep2o or Speedfit. Have a look under the sink, basin etc to see if any fittings are visible...

Most of the leading brands have their own, comprehensive installer guides, covering all aspects of product usage and installation. I’m taking it that Whitespeed (I’ve never even heard of them before) don’t have such a guide. Personally, if going down the pushfit route, I would steer clear of...

As far as I’m aware the issue has been fixed by firmware updates. The last few systems I have installed have been Hikvision Turbo 4 DVR with 5MP cameras. I have run cat5e cable instead of coax and used baluns at each end, the cat5e cable takes the power as well as video and works very well...

As above, replace fitting “like for like” so that the “O” ring sits on the same undamaged section of pipe, also give the fitting a pull back to make sure the teeth bite ok where the damaged pipe is.

I used to fit Torbeck valves but much prefer Fluidmaster with the brass tails. PRO45B / PRO75B and the relevant cistern repair packs Never had a problem with them.

OP’s username Isabelle Hanlon, made me smile .

I find that DryLine Pro fixings are very good for for “dot ‘n’ dab on all blocks / brick. I use them for hanging TV’s, kitchen units, radiators etc.

You could be sat on a beach on the other side of the world for 2 or 3 weeks. I’ve installed / upgraded a number of systems with Hikvision DS-72** HUHI K1 DVR’s and 5mp TVI cameras with excellent results. Some I have reused the existing coax and when adding new cameras I have run cat5e and used...