Search results

Yes as above. Have you checked that control panel has mains power?

What was the diagnosis of the problem. How was it sorted?

Post photo of door contact. If you are on a maintenance contract then company should deal with problem ASAP, usually within 4hrs. If not on contract then next working day to sort. Most wired alarm systems can be fixed with various makes of equipment eg door contact and pirs. Would not recommend...

Normally reds for 4k7 &2k2

Not a fan of Texecom Capture range. The locking mechanism is rubbish,would have been better with metal on metal fixings.

I've known this fault on c&k 700/800. Output gone faulty. Option would be to put strobe on bell output,or change control panel.

Have you got engineer code? Arming options then timers.

Mains light should be lit if mains power on,if off you are on battery back up. What are rest is fine ? Is the tamper trb light lit ? Just say exactly what leds are lit up or take photo of keypad so we can see. You need to tell us the answers to our questions,so we can advise you. The rest is...

Have you got mains led light and day light led lit on keypad ? Any other leds lit up?

What lights are lit on keypad when trying to set.

Always isolate the mains power safety when working a system which you are unsure of any faults. Flashing strobe can mean various faults eg, faulty battery, tamper fault etc. If tampers are not activating then they may not be connected or linked out. Not sure what you mean be wire attached to box...

If early 90s panel,then 123400 to get into engineering. The programming menu is then mostly the same as current functions.

You need to check the front door contact lid is securely fitted,also you will need to check the rear tamper knockout has not been broken. Best to post photo of rear mounting plate of the door contact with pcb removed. Common fault when upvc door fitters damage units. If broken then new contact...

Total power down battery and mains and re boot control panel. Possible that panel was stalled during power off due to Possible faulty battery as already mentioned. If still faulty then wire keypad that is causing issue into control panel on temporary lead. Also check dil switch settings on both...

If locked you can't reset code.The panel is then locked to factory default settings. Basically panel will need replacing.

If your system has defaulted back to factory settings and the default engineers code does not work,then the control panel is engineer locked. The pcb will need to be replaced if locked. What code are you using as engineer code ?

From programming, go to coms. Arc ,then turn off open/ close reports.

Is some water required with it. Or is it predictive text finger trouble.

I would go with the Premier elite 24 if your budget will allow.Better false alarm management for fault finding and upgradeable if required. The excel lcd keypad functions are not great.

Veritas programming is one of the easiest. Option to Install new veritas straight swap. Elite panel is next up in the range and would cost more to replace. Programming from keypad is hard than linked to laptop with Wintex software.