Search results

Two of these were supplied with my thermostatic shower mixer. I fitted them but still wondered why you would want to restrict the flow?

No. The trv senses the room air temp and opens or closes to maintain the temp you have set on it. The system should stll be balanced.

They are about 10mm deeper than the carcase to hide part of the door edge. This is the only option at ikea. They do not do ones with the holes drilled in them to replace part of the carcase. All carcases from ikea are white.

My Ikea cover panels measure 14mm thick.

My Valliant Ecotec Plus is virtually silent and to an amateur (me) it looks better quality than my friends WB.

Could be the machine. My old one shook a lot from new. My new Hotpoint starts to spin and if it senses the clothes are out of balance it stops jiggles them around a bit then restarts. Virtually silent and dead still.

Cheers pukka will check that if the new lamps don't work.

And I thought I had made the joke just obvious enough. :lol: Glad you got it Loverocket. :D

But its made by whirlpool for Ikea, or it it just cheap lamps?

No visible cables. Must be underground.

Don't think it is connected because this happened at the instant I switched it on but there was a thunder storm at the time. Anyone any ideas?

Just took another picture of the fitting because it does not look like a lamp not fully screwed in could cause a bad connection on the SIDE of the Edison. Looks like is is sprung to me. Any ideas? Not a bad for a picture taken through a 30mm inspection mirror. :D

Pulled out my Ikea Extractor hood tonight and got a fright. A bright blue flash and pop then a completely dead cooker hood (no lights or fan). Was going to just return it but after digging out the receipt its 14 months old. So checked the 5A fuse in plug and it was blown. Replaced it and fan...

On mine the flue gas (inside pipe) is open to the sky. The outside combustion air pipe is protected from rain by a hat so it can only draw air from underneath. 2 years old.

BSS will be able to supply the 25mm BS1387 pipe and the mallable iron fittings. Dont know if they will cut and thread it. I think 32mm will be a better size.