Search results

Best to leave all the work to your Gas Safe man.

Ignore that ^ For the warranty Id go for the baxi. Presumably its a duo-tec/platinum? Decent boilers.

I like him :D 10mm doesn't exactly need alot of support and if your gonna re-tile then he's done you a favour. They always look much better sticking straight out the wall.

Are you choosing Ferroli because it's cheap? If so dont expect much of an after sales service. If you want aftersales go for Baxi/Potterton or Worcester. Wont be as cheap as your ferroli though :D

What fault is it locking out with?

No. Needs to be after pump but before the motor valves

Assuming this is a eurocombi the furthest left led indicates ignition failure. Most of the checks would involve gas but you could check the right hand board which monitors flame rectification.

Is that a new instruction. I've spoke to them a while ago (maybe 2years) and they were adamant that it can stay in until your happy with performance there's also no mention of this on the actual product.

Is there a reason for this or just bad design?

would probably involve more "stuff" below the base of the bath of which there usually isnt the room. Next time get the waste put the opposite end to where you stand. Simples!

Did you just make that up?

Is your bath tap mains water then?

Check you flow rate of the mains water. This is what determines if you should get a combi and if so what size. Your back boiler was sized to match your radiators. Combi boilers are sized to match the water flow rate. Its a litres per min figure so get a bucket and stop watch. Even the...

Great boiler and well worth repairing IMO

Its a plug in a gas pipe. leave it alone :shock:

If they put enough signs up then surely he is agreeing with the service and charges to go with it

When you link out the microswitch. What happens?

Did you replace the diverter valve complete? Does it work if you link it out or does it show any signs of bockage?

AFAIK the latest regs say the pipe can be buried but must be removable for inspection. Any fittings you put in the floor must also be inspectible. Not easy if you're tiling the floor. Ive just renewed mine at home. I ran all the heating in 10mm hep off a manifold to minimise fittings in the...

No one here will be surprised to hear you say that.