Search results

Friend of mine had a Vauxhall brought after market sensors had a nightmare trying to get them to work ,had to buy Vauxhall own, worked straight away

Could be your starter motor relay, look in handbook for location usually in engine fuse compartment . Its normally a 4 pin relay so could be swopped with another 4 pin relay in fuse box to confirm fault

Winston1 So you can be wrong I will say it once more it might sink in .I used the same wording as Bling to save confusion with him, yes I could explain its a consumer unit to him but I am trying to help him address his problem. End of story not to teach him correct wording for every part of...

Winston1 Where did I say . I switched of the power to the fuse board ? Like i said Bling called it a fuse board and to save confusing issues I used the same terminology

Winston1 I know it's called a consumer unit. As explained early

Winston1 Bling called it a fuse board and to save confusing issues I used the same terminology Stop being a Kn_b

Gap around fire looks to small should be 150 mm ,they are the figures I was given when had one fitted and looking on google same figure keeps coming up ,the heat can not escape and walls are being used as a heat sink.(and lack of air flow round the fire) How much difference it will make I cant...

Have you actual tested for power at the unit .? What have you in your fuse board normal MCBs or RCBOs or a RCD covering MCBs If RCBOs or a RCD might be worth turning it off and back on as sometimes when they trip it may not look like they have ,not gone all the way down

What about if wrapped before hand,like when laying pipes into screed ?

When was the rad fitted ? has it ever warmed up ?

long shot. Have you removed connector of alternator and checked for corrosion like I said long shot but have had this once

Readings taken on ground ,then lifted in air to adjust rack ,then once set car lowered and rocked back and forth before re-checking.

How about using a kinetic switch https://www.quinetic.co.uk/ No wires at all at cabinet

More then one turbo boast hose need to look /check them all out

:D

Need to read fault codes. But I had a problem similar. Running on cruse control variable veins on turbo stayed stuck open as when on cruse control and more speed is needed ie up a incline you are given full throttle by cruse control module and this fully loads turbo causing veins to open fully...

HI FrodoOne Thanks for all your help in this matter. I have viewed the video. We are going to see if we can run a new feed with a earth(cpc) to the pump

Hi FrodoOne I mean by no cpc is no earth wire in my main feed from house to pump socket just line and neutral . I have to look to see what supply I have, away from home for a few days . Thanks for your input Cheers kevin

HI Winston Thanks for your reply ,yes in Spain. I have a RCD in main board ,the feed to the pump is about 20 meters, just has line and neutral going into a socket and the pump which is wired with a cpc which is plugged in to that socket. I am asking as some people have a earth rod fitted and...

My main feed to the swimming pool pump has no cpc, It feeds a socket with a timer plugged into it then the pump plugged into that the pump plug has a cpc. Shall I fit a earth rod and earth original socket or add a RCD socket and use the earth rod for the RCD earth It is in a enclosed housing...