Search results

Thanks for the reply, yes I had a read of the manual and want much the wiser. Is suspect these are moderately specialist units for those ‘in the know’ not I in other words! I’ll give GJD a buzz as you suggest.

Hello all, I’ve had a rummage in the archive and can’t see anything similar to my query so here goes! Is the dygizone able to switch lights on at dusk and off at a set time then allow the sensors to take over or is it a one or the other arrangement? Also is there any benefit to connecting it...

Does anyone know the typical voltage for a defrost heater as I’d like to try and check mine. Bosch branded. Thanks.

Hi, I'm sure this is a common issue and I have followed other threads in attempting to diagnose and repair the issue. Symptoms are: Evaporator in the freezer ices up and the fridge compartment cannot be cooled. Checks undertaken: Thawed and removed the heating element and checked the...

Neat vinegar works for me on horses tail

Lookup ‘philmac’ fittings.

I would read that as u1 = l or n, u2 = l or n and one leg of capacitor, z2 = other leg of capacitor I will caveat that I’m not an electrician!

Control panel instructions attached, fault finding (not much use!) wiring info and dip switch settings.

If the connection on the pcb proves to be at fault you may be able to use one of the other connectors. Attached schematic may be of use.

I agree with what’s being said here regarding the lack of display on the control panel. The empty connectors aren’t necessarily a problem as they provide connections for a variety of system configurations (for instance air blowers, sensors, alarms etc). I’d go back over all the fuses on the...

When applying power to the motor does the fuse blow? Can you check for water ingress in to the white connector box on the left there? Looks like swa terminates there - could be damp. Running the unit without the discs turning means the sewage isn’t treated so it will be a bit smelly and you’ll...

How does your tank discharge? Has the level increased to the point where water could have ingressed the motor? Could you safely disconnect the cable from the control unit to the motor (as seen in the bottom of the above photos) and recheck / replace any blown fuses? This will rule out the...

The segment display should be illuminated when operating, either dots or dashes depending on the error state. Have you checked all the fuses? Interestingly it appears the kingspan beacon isn’t connected to this, that would provide an early warning the unit wasn’t operating correctly (the...

Check ‘everedge’ Expensive but works!

Check wedi, they have channel drains that don’t require envelope cuts.

I think it’s about 3 years now under an extended warranty - miele are closed until Friday and I was hoping it was something simple I can have a go at

Thanks I should have said it’s a 6000 series. I did look at previous threads weren’t relavent.

Frustratingly, our Miele dishwasher has just today displayed an F78 fault. I've followed the instructions and reset several times to no avail. Miele aren't open until next Friday Any suggestions for alternatives to try other than a simple reset? Thanks

thanks Gerry and apologies for the typo on the previous message. The handle is solid and held in place with a single screw. The handle I had in mind is about 45cm from memory but I don’t have the drawing to hand right now

Thanks I did try the berkshire wood turners none of their members were interested. I’m happy to pay postage Gerry if you’re willing to help? Thanks Simon