Search results

Yes we have a modern RCD consumer unit and have had this fan for several years. It’s a pain to swap the adapter between my toothbrush charger and the fan.

I’m attempting this and come across an unusual configuration. Here is the tap When I remove the lever, I have this The body of the cylinder is set inside the body of the tap. With previous taps, the body of the cylinder has been accessible at this point. I put my grips on it and away we...

Gifted to us. From India.

I have a plastic pedestal fan that has a two pin plug. I’ve been using a 2 pin to 3 pin adapter. I was wondering if I can just replace the two pin with a regular UK plug? Is that safe to do? I assume the fan only has a live and neutral at present and didn’t know whether the adapter provides...

I’ve previously been applying deck paint using a brush and it’s been a time consuming process. Seen a YouTube short where the chap is using a roller on a pole. I have the pole but wondering what type of roller I should use?

Does that explain why I can blow straight through this? It’s a hollow section of small curved plastic pipe at the moment.

Sure. Very obvious. Not sure why they bother with SUPPLY/LOAD on some of these units. Low IQ manufacturers I guess. Good day @Taylortwocities!

I think you’ve got a pull switch there? Like this one:

When I switch the shower on, water trickles out of a small black outlet. I unscrewed it and it has a rubber grommet which appears to be fine. Any ideas on what might be causing this?

It was indeed the cables that needed switching around but in the electricians defence, there was no “supply” or “load” printed on the terminals. It was an MK 2 gang switch.

Oh ok. It’s bang on centre.

The builder put the rad in originally but there was a leak and that was British Gas, with the compression fittings and busted wall. The rad is centralised. The centre of the rad is exactly the centre of the window. I wasn't sure what you meant.

That's a badge of honour coming from you. Appreciated.

I've got something similar to this for an electric shower. The on/off operation works correctly and supplies/disengages power to the electric shower. However, the neon light always stays on. I've not looked inside yet. Can this be fixed or does the whole switch need to be replaced? Thanks for...

Oh, that was my heat shield to protect the wall!

UPDATE - wanted to share how I got on earlier today. System pressurised again and nothing has burst yet! There’s probably many things I’ve misunderstood and done badly. I would welcome your feedback as I’d like to learn for next time. Thanks again guys. Really appreciated your advice with this

So if I am doing this work over a couple of days, I need to fill up the system again with rad pipes capped off as else there will be no hot water. And then the following day I need to drain down again, put the rad in and fill up again. Have I got this right? Thanks for your help.

I need to do some maintenance on a rad and wanted to check if the boiler can continue to run with 0 pressure on the boiler and whether this will affect hot water supply?

Can I safely solder in here? I need to extend these pipes down for radiator fitting. If yes, what can I use to protect the cable from the flame? Thanks in advance.

I think you are suggesting that both pipes come out around here? You can see that the current white pipe is coming out at an angle and I think that's because of the skirting board sitting proud of the level the pipe sits in within the vertical boxing. How will I be able to have these pipes...