Search results

went with diamond core. they were new and hard as steel but it went okey

as title does anyone have a good method of drilling hanging tiles seem to have a few unvented cylinders at the moment and a few of them have this issue

I agree cust from hell all very well he can find it on internet for £1250 but a local installer want to buy locally and get support from the seller if things go wrong what if 600mm flue too short what if the condense cant be put where he imagines it cut and paste plumbing he will get what he...

how do you mark the screw holes to refit a rad

you know the fault you decide the cure you bought the part and now you want some one who knows familiar with this heater. When he fits your part and its still the same who will you blame I live near you I,m qualified by training experience and by gas safe so why would I want you looking over my...

I have just had the front garden block paved as is ever the case my wife waited till the end then asked me "why didn't they put membrane down it will be all weeds" do you normally have a membrane under block paving

gas rate at low rate flue gas inspection que signor

I,d like that sheet on the ap switch tester if you don't mind

I want to write a spec to have our dormer flat roof re covered I believe 18mm ply as a sub strate but want to specify so we get what we need for a habitable roof

my dormer bungalow has a built up felt roof that needs replacing I want value for money and quality as opposed to price it does join next doors flat roof which is built up felt and I will need to join it does that affect my options what is the best material to use rubber glass fibre or is there...

the problem is the pan supports are only 3-4mm wide and pans particually frying pans slide like torvill and dean as the is a wide base and very little friction to stop the pans from sliding has anyone a similar problem and have they found an answer complaining only gets you new pan support which...

it was a general question I follow the concept if there only 24v going thru it the anticaptor wont work

will this room stat work okey with a combi boiler

i have a whirlpool generation 2000 built in eletric oven model BS0801/WH my problem is there is an air gap between the two glass panes in the door and this now has marks on the inner surfaces of the glass does anyone know how to dis assemble this door an email to the makers met with no success...

i,d be quite interested if you know of how they view it i have been on the outside of an expensive case and some commercial systems are now treated with biocide rather than cleaners this is very much a black art and i dont fully understand it but some of the cleaners rob the water of its buffers...

germany didnt indulge in the early viessmann (dover 100) it was made just for us and thats a pile of rubbish we bring a lot of this on ourselves

i feel like wb pr now but the manuals roughly page 12 mention fitting shock arrester re protecting hydro-bloc what we prefer is our own view mine is the broader proper regulation of a qualified work-force would be a good thing and cost effective but i will die before that happens

worcester think in german you pay roughly 4 times as much to have it fitted in germany the guy is properly qualified and the install is to a high standard im english and im not here to rubbish us but bosch wont accept this is their fault it a bad install