Search results

700euro to change a ball valve and syphon or flapper? jesus i should move to spain.

is it gravity Hot water?

Just get your gas safe guy to order it he can give them his number and add to your account if your there.

I'm not doing the digging, you think i'm stupid, i only doing cooper to the MDPE above ground and joining it above ground. Just the above ground cooper i wasn't sure on insulation levels or even where to get it. The stop cock is under the sink about 500mm from where i want to come out.

Wen't to look at a job, a guy has had this great big "shed" built looks like a house to me but anyway he has a water supply in the kitchen what he wants is it run out, down and then back up on the outside of the shed and then into the shed. I have never really done any extention or anything...

Prepayment meter? run out of money?

Denso, if your feeling in a sharing mood, mine are in my profile always looking to add to what i have lieing around :)

i have seen these bearhugs are they actually any good though, i'm all for something that makes my job easier but haven't been able to get hold of one to play with

twelfty, Your Clever ill give you that, using the linkage and page rank from this site by using your desired key terms and a link to your site, if only i was allowed to do that it would bounce me a few good places. Regards

Should of been covered during your G3 Unvented

Thanks Tony, I found them but no 28mm ones? I will keep looking for them Thanks Again

I answered my own question while googling re: ideal standard still looking for the washers http://www.fastpart-spares.co.uk/viewproduct.asp?P=E999067 Even has Extras :-) but will do fine unless someone knows somewhere without a £7.50 Delivery Charge? Thanks

Just wondered as these are getting harder and harder to get from local merchants, i would ask if anyone knows of anywhere reasonable priced to get them from I am after the truly Flat machine pressed ones with the ideal standard round dounut. Links and Prices would be appricated, I also...

Tony, While this is true, getting them can be a little harder than it sounds when your local merchant doesn't appear to stock them anymore., i heard BES sell them but can never find them, where do you get yours from Tony

The water is probably being pushed up through the cold feed in the f and e tank, my suggestion Close the Ball Valve either turn off or tie-up Bale out water to the water draw off level shouldn't be a lot and watch, see if water starts to come out of the draw off if so you have a coil hole...

To the OP in future your local trading standards buy with confidence scheme, where they vet, CRB check, Finacial Check companies before adding them to the list. Or CIPHE site,

Lol its a joke, My Card only has ONLY NG on My Detials on Site include All my LPG excluding LAV but does include RPH NO Unvented on either WTF Just got to watch i suppose and wait and see and keep bajuring them. I will give them a ring tomorrow see if i can get it fixed can anyone...

i have mine but no LPG and UVHW but told there not adding UVHW is this correct?

Thats well-out, i missed that how tight can you be