Search results

£92 to me as Vat registered :lol:

£92 all in is not bad for 16 way board with MCB's to suit

with 3 boards first thing i would be questioning is why? has a bodge up been done before or is one an economy 7 or 10 supplied board? like already sugggested an EICR would be the only sensible route to be sure what is already existing and how safe it actually is! just this morning i went to...

depends on the spec. cheap materials or top notch chrome/gold plated ? fire rated or normal downlighters? chased or surface wiring? the list could go on. £5K for a basic is over the top but 35k for all singing with bells on wouldn't be!

any other make i would say ok FOCALSHITE i would avoid like the plague! cheap nasty appliances put together by multinationals for a company that doesn't give a hoot for customer service the IDEAL Boilers of the fire world! is that clear enough what I and many others think of the company and...

if you are worried that the concrete will go through just wrap the insulation in a tape like closure plate or duck tape to provide a water proof barrier and clip off all those cable tie ends!!

internal filling loop on these and yes a small spanner (8mm if i remember) is best to open the 2 valves = absolute pain in the aris to use !! good luck you need about 1.2 - 1.4 with system cold or 1.7 - 1.9 if hot.

24 kw = luke warm water 27kw = hot water if you're lucky 30kw = reasonably good hot water 37kw or higher = excellent hot water all the above rely on the fitter ensuring that the gas supply is adequate, what size pipes do you have and approx length of pipe run from meter? personally i...

exactly what i thought, found out that the custs brother did the work!! now i have to find the cheapest/easiest route to putting it right!! think the only solution will be a new 4 core cable between them and scrap one of the supplies plus of course an isolator somewhere in the system.

prentice when i say loose i mean just the connector cable I:E just 6" of cable at each alarm! yes i agree that the safest way is to run a new supply between them and power off one circuit. but i need a reason to fail it that holds water! as they say you can make things idiot proof but a...

thanks alarm, so the link wire isn't connected directly to the LNE then? wasn't sure hence the question, haven't come across this before!

no link wire that is part of the question :D

so the situation is a domestic house with upstairs smoke on upstairs light circuit, downstairs smoke on downstairs light circuit the linkwires are just loose in each, no isolation from lights on either. both light circuits are on same bus bar no rcd protection just a 100A double pole switch...

it says 418 in the OP!

personally i would stick with the 392 over the 430 i have had no problems with them, the 430 well thats a whole story in its self set up so the 2 zones can run together rather than hot water priority set D.77 to 12 otherwise you will get excessive noise issues when in hot water only (comes...

yes i agree with you john but if you sad enough allow photographing by your partner you only have yourself to blame. now wheres my camera!! :lol: :lol:

not yet! but the sooner the better

don't mind a bit of it but not all day long!! :lol:

listen to Breeze or absolute 80's most of the time as they play some good stuff, saturday/Sunday night old skool disco/Glitz mix on wave 105 always listen on my way back from Sussex

they should close down the "carwash" the ones run by groups of immigrants with buckets excetera